Q-Logic 2300 series manual Setting the QSB2340/2342 HBA Connection Mode

4 – QSB2340/2342 FCode

Q

4.3.2

Setting the QSB2340/2342 HBA Connection Mode

Perform the following steps to view the current QSB2340/2342 HBA connection mode and change it if necessary:

1.Perform steps 1 and 2 in section 4.3.4.

2.To view the current connection mode, type the show-connection-modecommand.

ok show-connection-mode

The connection mode and options display. For example:

Current HBA connection mode: 2 - Point-to-point only

Possible connection mode choices: 0 - Loop Only

1- Point-to-point only

2- Loop preferred, otherwise point-to-point

3.If the connection mode is not correct based on the devices connected to the QSB2340/2342 HBA, change it using the set-connection-modecommand. For example:

ok 0 set-connection-mode

The new connection mode displays. For example:

Calculating NVRAM checksum, please wait...

Current HBA connection mode: 0 - Loop Only

Possible connection mode choices: 0 - Loop Only

1- Point-to-point only

2- Loop preferred, otherwise point-to-point

4.3.3

Setting the QSB2340/2342 HBA Loop ID

When the QSB2340/2342 HBA is currently operating in loop mode (through connection mode 0 or connection mode 2), perform the following steps to view its loop ID and change it if necessary.

1.Perform steps 1 and 2 in section 4.3.4.

2.To view the loop ID, type the show-adapter-loopidcommand.

ok show-adapter-loopid

The loop ID displays. For example:

Adapter loopid - 7c

4-4 CF2351102-00 F