Peavey CC 2800, CC 4000, CC 1800 owner manual Installation, Unpacking, Mounting, Connecting power

2installation

unpacking

Upon unpacking, inspect the amplifier. If you find any damage, notify your supplier immediately. Only the consignee may institute a claim with the carrier for damage incurred during shipping. Be sure to save the carton and all packing materials. Should you ever need to ship the unit back to Crest Audio, one of its offices, service centers, or the supplier,use only the original factory packing.If the shipping carton is unavailable, contact Crest to obtain a replacement.

CCTM owner’s manual

For replacement	+
packaging, call Crest
Audio’s
Customer Service
Department directly.

see—service and support

mounting

CCSeries amplifiers will mount in standard 19" racks. Rear mounting ears are also provided for additional support, which is recommended in non-permanent installations like mobile or touring sound systems. Because of the cables and connectors on the rear panel, a right angle or offset screwdriver or hex key will make it easier to fasten the rear mounting ears to the rails.

connecting power

CCSeries amplifier power requirements are rated at 1/8th power (typical music conditions) and 1/3rd power (extreme music conditions).The maximum power cur- rent draw rating is limited only by the front panel circuit breaker. Consult the speci- fications in the Appendices section for figures on the current that each amplifier will demand. Make sure the mains voltage is correct and is the same as that printed on the rear of the amplifier. Damage caused by connecting the amplifier to improper AC voltage is not covered by any warranty. Unless otherwise specified when ordered, Crest amplifiers shipped to customers are configured as follows:

Option 1 North America	120VAC / 60 Hz
Option 2 Europe,Asia	230VAC / 50 Hz
Option 3 Australia	240VAC / 50 Hz
Option 4 South America	120VAC / 60 Hz or 240VAC / 50 Hz

Always turn off and disconnect the amplifier from mains voltage before making audio connections. Also, as an extra precaution, have the attenuators turned down during power-up.

a

p. 4