Peavey CC 4000, CC 1800, CC 2800 owner manual Specifications, Cctm Series

Net Weight

Gross Weight

aspecifications

CC™ owner’s manual

CCTM Series	1800
Rated Power Bridge 4 ohms	1850 watts @ 1 kHz at <0.1% T.H.D.
Rated Power (2 x 2 ohms)	900 watts per channel @ 1 kHz <0.05% T.H.D. both channels driven
Rated Power (2 x 4 ohms)	700 watts per channel @ 1 kHz at <0.05% T.H.D. both channels driven
Rated Power (2 x 8 ohms)	450 watts per channel @ 1 kHz at <0.05% T.H.D. both channels driven
Rated Power (1 x 2 ohms)	950 watts @ 1 kHz at <0.05% T.H.D.
Rated Power (1 x 4 ohms)	775 watts @ 1 kHz at <0.05% T.H.D.
Rated Power (1 x 8 ohms)	475 watts @ 1 kHz at <0.05% T.H.D.
Minimum Load Impedance	2 ohms
Maximum RMS Voltage Swing	73 volts
Frequency Response	10 Hz - 100 kHz; +0, -3 dB at 1 watt
Power Bandwidth	10 Hz - 50 kHz; +0, -3 dB at rated 4 ohm power
T.H.D. (2 x 2 ohms)	<0.2% @ 700 watts per channel from 20 Hz to 20 kHz
T.H.D. (2 x 4 ohms)	<0.1% @ 600 watts per channel from 20 Hz to 20 kHz
T.H.D. (2 x 8 ohms)	<0.1% @ 425 watts per channel from 20 Hz to 20 kHz
Input CMRR	> - 75 dB @ 1 kHz
Voltage Gain	x40 (32 dB) x20 (26 dB)
Crosstalk	> -55 dB @ 1 kHz at rated power @ 8 ohms
Hum and Noise	> -106 dB, “A” weighted referenced to rated power @ 8 ohms
Slew Rate	> 35V/us
Damping Factor (8 ohms)	> 150:1 @ 20 Hz - 1 kHz at 8 ohms
Phase Response	+6 to - 12 degrees from 20 Hz to 20 kHz
Input Sensitivity (x40)	1.32 volts +/- 3% for 1 kHz, 4 ohm rated power, 1.06 volts +/- 3% for 1 kHz, 2 ohm rated power
Input Impedance	15 k ohms, balanced
Current Draw @ 1/8 power	1,000 watts @ 2 ohms, 685 watts @ 4 ohms,
	400 watts @ 8 ohms
Current Draw @ 1/3 power	2,340 watts @ 2 ohms, 1,650 watts @ 4 ohms, 1,000 watts @ 8 ohms
Cooling	One back panel temperature dependant variable speed 80 mm DC fan
Controls	2 front panel attenuators, rear panel Mode switches
Indicator LEDs	2 ACL™ (automatic clip limiting), 2 Signal presence, 2 Active status, 2 Temp
Protection	Thermal, DC, turn-on bursts, subsonic, incorrect loads
Connectors	Combi XLR & 6.3 mm phone input, Speakon and 5-way Binding Post speaker output, 15 amp
	IEC mains connector
Construction	16 ga. steel with cast front panel
Dimensions	88.9 mm x 482.6 mm x 377.8 mm + 31.8 mm for rear support ears and connectors
	(3.5" x 19" x 14.875" + 1.25")

14.8 kg (32.6 lbs.)

15.9 kg (35 lbs.)

All power measurements made at 120 VAC, power transformer cold. 2 ohm power is time limited by magnetic circuit breaker.

p.14