JVC DLA-G150CLU, DLA-G150CLE Insert the new light-source lamp fully, Inside and fasten the screws

Page 31

Replacing the Light-Source Lamp

■Be sure that the power cord is unplugged from the wall outlet.

1 Remove the lamp-replacement opening cover by loosening screws.

 

Replacing the Light-Source Lamp

3 Insert the new light-source lamp fully

Light-source lamp

inside and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

 

Loosen the two screws with a flat-end screwdriver.

CAUTION

Note

•The screws are fitted so that they do not come off the lamp- replacement opening cover.

No.

 

51931

2 Loosen the screws, raise the handle,

 

 

and pull out the light-source lamp.

 

Loosen the two screws with a flat-end screwdriver.

Note

•The screws are fitted so that they do not come off the light- source lamp.

Screw

Lamp-replacement opening cover

Be careful not to damage the claw.

Screw

• Do not touch the glass surface of the light-source lamp

 

directly with your hand as well as staining it. If you touch

 

with a bare hand, oils and other substances on your hand

 

may adhere to the lamp, possibly preventing it from

 

performing as specified and therefore giving a shortened

 

lamp life, a darkened screen, etc. To handle a new light-

 

source lamp, hold it by the plastic part. Never touch the

Handle

metal part or the front glass surface.

4Replace the lamp-replacement opening

cover and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

CAUTIONS

• Install the light-source lamp and close the lamp- replacement opening cover correctly; otherwise, a safety

switch is activated to prevent the projector from operating.

• If the claw on the lamp-replacement opening cover is damaged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover.

5Reset the lamp use time.

Perform “Resetting the Lamp Use Time” on page 62.

Screw

Lamp-replacement opening cover

Be careful not to damage the claw.

DEUTSHENGLISH

Light-source lamp

Handle

(To be continued on the next page)

60

1-31

61

ESPAÑOLITALIANO FRANÇAIS

DLA-G150CLU DLA-G150CLE

Page 30 Page 32
Image 31
Page 30 Page 32
Contents DLA-G150CLU Can Result About the installation placeDo not allow any unqualified person to install the unit About burning-in of the D-ILA deviceContents Controls and Features Control Panel on the Projector Bottom SurfaceConnector Panel Remote Control Unit Installing Batteries Installing the ProjectorPrecautions for Installation Leveling the projector Adjusting the Inclination of the ProjectorInstalling the Projector against the Screen Adjusting the vertical angle of the projectorProjection Distance and Screen Size Setting the Amount of Lens ShiftingUsing as a wireless remote control unit Effective Range and Distance of the Remote Control UnitSetting the Position Selecting Screw for Ceiling Mounting When installing adjusting/setting the unitAllowable input signals Connecting to Various DevicesSignals that Can Be Input to the Projector Video signalsConnecting to Hi-Vision Devices/DVD Players Connecting to Video DevicesGame device, etc Desktop type Connecting to Other DevicesConnecting to Devices which Control the Projector To ControlConnecting to DVI Connecting to Computer DevicesHow to attach the ferrite core To prevent fire and electric shock, observe the following Lamp control settingsBasic Operations Removing the Lens CapProjector’s buttons Turning on the Power Turn on the Main Power switchRemote control unit Turning off the PowerSetting the Screen Aspect Ratio Remote control unit Turning off Image HideRemoving the Trapezoidal Distortion of the Image Zooming a Part of the Image Remote control unit Quick Alignment FunctionDisplaying a Still Picture Freeze Submenus in Video Menu Mode Menu Transition Diagram in No signal Menu ModeMenu Transition Diagram in Video Menu Mode Quick Reference Guide for No signal Menu ModeFactory set value Menu Transition Diagram in PC Menu ModeFor Video Menu Mode Quick Reference GuideBasic Menu Operation Press the cursor Button 2 or 3 to set Or adjust the valueQuick Reference Guide for PC Menu Mode Remote control unit ProjectorProjector Changing the Color System Video Menu Mode OnlyVideo menu mode PC menu modeOr Hdtv with the cursor button 5 or ∞ Adjusting Tracking/PhaseAdjust the Screen aspect ratio Changing the Language DisplayMake adjustment with the cursor2 or Set up for Watching Image Software Video Menu Mode OnlyAdjusting Picture Quality Select the item to be adjusted with the cursor button5 or ∞Cursor button Or ∞ Adjusting the Video Screen/Menu PositionAdjusting Color temperature Adjust the color temperature with Cursor button2 orSelect Resize with the cursor button 5 or ∞ Changing the Image Gamma/Aspect Ratio Video Menu Mode OnlyChanging the Image Size Resize Function PC Menu Mode Only Select Gamma or Aspect ratio with the cursor button5 or ∞Or∞, and press Setting and Adjusting Other Functions OptionsAdjustment item Button Or∞, and press the Enter buttonProjector and the wall outlet Replacing the FuseGetting Information Select Information with the cursor button5 or ∞Light-source lamp and lamp use time Replacing the Light-Source LampLoosen the screws, raise the handle Reset the lamp use timeInsert the new light-source lamp fully Inside and fasten the screwsCleaning and Replacing the Filter Cover Maintenance TroubleshootingWhen warning indication is shown by the blinking indicators Operate Indication IndicatorAction to be taken for warning indication Lamp TempPressing any button To cancel this message, pressPower Control Mode LPC Message is cleared byGL-M2915SG SpecificationsEnglish Deutsh Français Italiano Español Pin assignment Specifications for terminals Outside dimensionsRS-232C external control Communication SpecificationsCommand Format Control command tableFor AppendixDLA-G150CLEINSTRUCTIONS EMC To the following power supply voltage. Use onlyPower cord designated by our dealer to ensure Safety Fire HazardReplacing 15the United Kingdom onlyVarious Devices BNC-RCA Conversion plug Deutsh Front Side / Top Surface / Right SideApprox m Ferrite core ⋅ Conversion adapter for Mac for MacintoshRear adjustable foot for leveling the projector Control Panel Projector Stand by IndicatorButton does not work Button to obtain a still pictureGebruike batterijen PC buttonsInstalling the Projector GL-M2930SZG EnglishRemote control unit Response to color systems systems 640 400 24.83 56.42 To Video Video cable accessoryHor Pixels Ver Lines KHz PC system PC98 640 350 37.86VHS VCR BNC-RCA conversion plug accessory To VideoTo Y To PB/B-Y Game device, etc Hi-Vision devicesConnector Connection cable supplied To RS-232C connector To Remote terminal To monitorCable Supplied Ferrite core Basic Operations Image will be displayed in full Side of the unit is projectedComp The image from the Comp Y, R Pressed PC1 ↔ PC2 ↔ DVIQuick Alignment Function Quick Align No.51931Main menu in No signal Menu Mode Quick Reference Guide For Video Menu Mode Options → Refer to Phase Flickering or dim picture image can be adjusted toInformation → Refer to Menu returns to the previous menu RestoredAuto Adjusting Tracking/Phase Image adj. submenu appears on the screen Adjust the color temperature with Cursor button 2 orOr ∞, and press the Enter button. Then, the All Video submenu Video submenu Set up 1 submenu Image enlarged to the full size 1365 ⋅ Españolitaliano FrançaisdeutshenglishExceeds 2000 hours Press the Menu button to exit the menu modeReplacing the Fuse Cover by loosening screws Stand by indicator Projector’s button Turn on the Main Power switch to goScrew Lamp-replacement opening cover Hide button Blocked? WithWhen warning indication is shown by the blinking indicators Message Cause Corrective action Input terminals SpecificationsOptical mechanism system Electrical systemGeneral FrontUnit mm Designates the terminal of the data Dh 21h Control command to the projectorFunction Command Asking Operation Mode parametersFor lens unit GL-M2910G Español 2002 Victor Company of JAPAN, Limited

DLA-G150CLU, DLA-G150CLE specifications

The JVC DLA-G150CLU and DLA-G150CLE projectors represent the pinnacle of home cinema and professional presentations, offering exceptional picture quality and advanced technological features. Both models are designed to deliver an immersive viewing experience, leveraging JVC’s years of expertise in projection technology.

These projectors incorporate JVC’s renowned D-ILA (Direct-drive Image Light Amplification) technology. This innovative system utilizes liquid crystal on silicon to achieve stunning color accuracy and contrast. The DLA-G150CLU and DLA-G150CLE boast an impressive native resolution of 1920x1080, allowing for incredibly detailed images that are perfect for both high-definition films and intricate graphics. The contrast ratio of these projectors reaches up to 20,000:1, making dark scenes richer and more dynamic while ensuring bright areas remain vivid without washing out.

Color reproduction is another strong point of the JVC DLA-G150 series, featuring an expansive color gamut that adheres closely to industry standards. The projectors utilize a dual-lamp system, allowing for increased brightness levels of up to 2500 lumens, which ensures clear visibility even in well-lit environments. This feature is particularly beneficial for presentations in conference rooms or larger venues where ambient light may compromise image quality.

Both the DLA-G150CLU and DLA-G150CLE support a wide range of connectivity options, including HDMI and RS-232 ports, making them versatile for various setups. This connectivity is further enhanced by an intuitive on-screen menu system, allowing users to easily adjust settings and calibrate the projector for optimal performance.

For those who value flexibility, the JVC DLA-G150 projectors come with lens shift capabilities, enabling vertical and horizontal adjustments. This feature allows users to position the projector without compromising image quality, catering to different installation environments.

In conclusion, the JVC DLA-G150CLU and DLA-G150CLE projectors embody the perfect blend of advanced technology and user-friendly features. Whether used for home entertainment or professional applications, they offer unparalleled performance, making them an excellent choice for anyone seeking high-quality projection solutions.
Top Page Image Contents