JVC DLA-G150CLE, DLA-G150CLU manual Ferrite core

1-56

Connecting to Various Devices

Connecting to DVI

Before connection, be sure to turn off both the projector and computer devices.

• Read thoroughly the manual that comes with each device.

Connecting to Various Devices

Connecting	the Power Cord
After all devices have been finished being connected, connect the supplied power cord. At this time,		do	not yet turn on the
MAIN POWER switch	.
	1 Insert the supplied power cord into the
	power input terminal	of	the projector.

DLA-G150CLU DLA-G150CLE

DOS/V

(DVI VIDEO BOARD)

DVI (DVI-D 24pin Cable) (Available separately)

IN

R

G

B

H

V

P

P

	Ferrite core
2 Insert the	main plug of the supplied
power cord	into a suitable wall outlet.

Power cord (supplied)

No.51931

IN

Note

• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.

How to attach the ferrite core

Attach the ferrite core when using the S-video cable or infrared remote sensor extension unit which are sold separately. However, use a cable that can be wound once.

1Release the stopper at each end and

open the ferrite core.

ENGLISH

for European continent countries

for United Kingdom

CAUTIONS

To prevent fire and electric shock, observe the following:

• When you do not use devices, pull out their power cords

from wall outlets.

• Do not connect the devices with power cords other than

for European	for United Kingdom
continent countries

Note

• The power cord for the United Kingdom is only included as

a special accessory when shipped to the United Kingdom . It is not included when shipped to European continent

countries.

CAUTIONS

• Since the power requirement of the projector is high, insert

the power plug directly into a wall outlet.

• Use the supplied power cord with the ferrite core only.

• Do not remove the ferrite core from the supplied power

2Wind the cord around the ferrite core.

Attach the ferrite core about 3 cm from the end of the cord.

Stoppers

Wind the cable once.

DEUTSH

those supplied.

• Do not use mains voltage other than the power voltage

indicated.

• Do not scar, damage, or work on the power cords. Also, do

not put a heavy object on, heat, or stretch the power cords,

otherwise they may be damaged.

• Do not insert or pull out the plugs with a wet hand.

cord; Otherwise, there may be a possibility that a harmful

interference occurs.

3Close the ferrite core with the cord inside until you hear it click shut.

Note

•When connecting, connect the terminal which is at the ferrite core end of the cord to the projector.

Click!

ESPAÑOLITALIANO FRANÇAIS

Removing the Lens Cap

Remove the lens cap before using the projector.

Notes

•The lens cap is supplied with the lens unit (optional). It should be attached to the lens when the projector is not used.

•Do not operate the projector with the lens cap attached. Doing so can deform the lens cap because of the heat. A metallic lens cap can get hot and cause injury.

29

30