JVC DLA-G150CLU, DLA-G150CLE manual Rear adjustable foot for leveling the projector

Left-hand Side / Rear Side

	p Connector panel
	For details, refer to “Connector Panel” on page 11.
No.	q Rear adjustable foot (for leveling the projector)
	It is set at the shortest position when shipped from the
51931	“Adjusting the Inclination of the Projector” on page 16.
	factory. Turn the foot to make the projector level.
	Adjustment can be made in the range of +1.5° and –1.5°
	from the horizontal position. For details, refer to
	w Air inlet
	This is the air inlet. Do not cover or obstruct this slot.
	e Control panel
	For details, refer to “Control Panel on the Projector” on
	page 9.
	r Lens shift knob cap
	When you have mounted a lens that uses the lens shift
	function, open this cap and rotate the lens shift knob to
	move the lens position. For more information, refer to
	“Setting the Amount of Lens Shifting” on page 19.

1-45

Controls and Features

ESPAÑOLITALIANO FRANÇAISDEUTSHENGLISH

7

Controls and Features

Bottom Surface

t

y u

i

tAir inlet (filter)

Air is taken in through the filter to cool the light-source lamp. If the filter is blocked or if something that obstructs the flow of air is placed around the projector, heat may build up inside and could cause a fire. For required

space, refer to “Precautions for Installation” on page 15.

CAUTIONS

• Be careful as paper, cloth or soft cushion could be drawn in if placed nearby. Do not block the filter, or heat may build up and could cause a fire.

•Clean the filter periodically. For details, refer to “Cleaning and Replacing the Filter Cover” on page 63. Deposition of dirt on the filter reduces the cooling effect, causing heat to build up inside, which could cause a fire or malfunction.

yOpening for replacing the light-source lamp For replacing the light-source lamp, refer to “Replacing the Light-Source Lamp” on page 58.

uFixing foot

iPosition selecting screw for ceiling mounting When using the projector in an upside-down, ceiling-

mounted position (inverted top-to-bottom and right-to- left), the “position selecting screw for ceiling mounting” must be turned to switch to ceiling mounting.

This will correct variance in color images (shading), which otherwise would occur in ceiling mounting.

For more information, refer to “Setting the Position Selecting Screw for Ceiling Mounting” on page 21.

CAUTION

•To ceiling-mount and adjust the projector, special expertise and technique are necessary. Be sure to ask your dealer or specialist to perform this work.

8

DLA-G150CLU DLA-G150CLE

DLA-G150CLE