Texas Instruments TMS320DM643X DMP manual Mdio Control Register Control

Page 56

www.ti.com

MDIO Registers

4.2MDIO Control Register (CONTROL)

The MDIO control register (CONTROL) is shown in Figure 14 and described in Table 12.

Figure 14. MDIO Control Register (CONTROL)

31	30	29	28	24	23	21	20	19	18	17	16
IDLE	ENABLE	Rsvd	HIGHEST_USER_CHANNEL		Reserved		PREAMBLE	FAULT	FAULTENB	Reserved
R-1	R/W-0	R-0		R-1	R-0		R/W-0	R/WC-0	R/W-0		R-0
15											0
					CLKDIV
					R/W-FFh
LEGEND: R/W = R = Read only; R/W = Read/Write; WC = Write 1 to clear; -n= value after reset

Table 12. MDIO Control Register (CONTROL) Field Descriptions

Bit	Field	Value	Description
31	IDLE		State machine IDLE status bit.
		0	State machine is not in idle state.
		1	State machine is in idle state.
30	ENABLE		State machine enable control bit. If the MDIO state machine is active at the time it is
			disabled, it will complete the current operation before halting and setting the idle bit.
		0	Disables the MDIO state machine.
		1	Enable the MDIO state machine.
29	Reserved	0	Reserved
28-24	HIGHEST_USER_CHANNEL	0-1Fh	Highest user channel that is available in the module. It is currently set to 1. This
			implies that MDIOUserAccess1 is the highest available user access channel.
23-21	Reserved	0	Reserved
20	PREAMBLE		Preamble disable
		0	Standard MDIO preamble is used.
		1	Disables this device from sending MDIO frame preambles.
19	FAULT		Fault indicator. This bit is set to 1 if the MDIO pins fail to read back what the device
			is driving onto them. This indicates a physical layer fault and the module state
			machine is reset. Writing a 1 to it clears this bit.
		0	No failure
		1	Physical layer fault; the MDIO state machine is reset.
18	FAULTENB		Fault detect enable. This bit has to be set to 1 to enable the physical layer fault
			detection.
		0	Disables the physical layer fault detection.
		1	Enables the physical layer fault detection.
17-16	Reserved	0	Reserved
15-0	CLKDIV	0-FFFFh	Clock Divider bits. This field specifies the division ratio between the peripheral clock
			and the frequency of MDCLK. MDCLK is disabled when CLKDIV is cleared to 0.
			MDCLK frequency = peripheral clock frequency/(CLKDIV + 1).

56 Ethernet Media Access Controller (EMAC)/SPRU941A –April 2007

Management Data Input/Output (MDIO)	Submit Documentation Feedback

Image 56

Contents Users Guide Submit Documentation Feedback Contents MAC Hash Address Register 1 MACHASH1 Appendix a Appendix BList of Figures Transmit Pacing Algorithm Test Register Tpacetest List of Tables Fifo Control Register Fifocontrol Field Descriptions Read This First Features Purpose of the PeripheralFunctional Block Diagram Emac and Mdio Block DiagramSignal Descriptions Industry Standards Compliance StatementClock Control Memory MapEmac and Mdio Signals Signal Type DescriptionEthernet Protocol Overview Ethernet Frame FormatEthernet Frame Description Field Bytes DescriptionPacket Buffer Descriptors Ethernet’s Multiple Access ProtocolProgramming Interface Basic Descriptor Description Typical Descriptor Linked ListTransmit and Receive Descriptor Queues Transmit and Receive Emac Interrupts Transmit Buffer Descriptor Format Example 1. Transmit Buffer Descriptor in C Structure FormatNext Descriptor Pointer Buffer PointerBuffer Offset Buffer LengthEnd of Packet EOP Flag Ownership Owner FlagEnd of Queue EOQ Flag Teardown Complete Tdowncmplt FlagReceive Buffer Descriptor Format Receive Buffer Descriptor FormatExample 2. Receive Buffer Descriptor in C Structure Format #define EmacdscflagjabberBuffer Length Code Error Codeerror Flag Alignment Error Alignerror FlagCRC Error Crcerror Flag Jabber FlagEmac Control Module No Match Nomatch FlagInternal Memory Bus ArbiterMdio Module Components Mdio ModuleInterrupt Control PHY Register User Access Mdio Clock GeneratorGlobal PHY Detection and Link State Monitoring Active PHY MonitoringMdio Module Operational Overview Reading Data From a PHY Register Initializing the Mdio ModuleWriting Data To a PHY Register Example of Mdio Register Access Code Example 3. Mdio Register Access MacrosEmac Module Emac Module ComponentsReceive DMA Engine Receive FifoClock and Reset Logic Transmit DMA EngineTransmit Fifo MAC TransmitterMedia Independent Interface MII Data ReceptionReceive Control Receive Inter-Frame IntervalCollision-Based Receive Buffer Flow Control Ieee 802.3x-Based Receive Buffer Flow ControlTransmit Control CRC InsertionAdaptive Performance Optimization APO Interpacket-Gap IPG EnforcementTransmit Flow Control Speed, Duplex, and Pause Frame SupportReceive DMA Host Configuration Packet Receive OperationReceive Channel Enabling Receive Address MatchingReceive Channel Teardown Hardware Receive QOS SupportHost Free Buffer Tracking Promiscuous Receive Mode Receive Frame ClassificationReceive Frame Treatment Summary Receive Frame TreatmentMiddle of Frame Overrun Treatment Receive OverrunMiddle of Frame Overrun Treatment Transmit DMA Host Configuration Packet Transmit OperationReceive and Transmit Latency Transmit Channel TeardownTransfer Node Priority Reset ConsiderationsSoftware Reset Considerations Hardware Reset Considerations InitializationEnabling the EMAC/MDIO Peripheral Emac Control Module InitializationExample 5. Mdio Module Initialization Code Example 4. Emac Control Module Initialization CodeMdio Module Initialization Emac Module Initialization Interrupt Support Emac Module Interrupt Events and RequestsTransmit Packet Completion Interrupts Receive Packet Completion InterruptsHost Error Interrupt Statistics InterruptUser Access Completion Interrupt Mdio Module Interrupt Events and RequestsLink Change Interrupt Proper Interrupt ProcessingEmulation Control Power ManagementEmulation Considerations Emac Control Module Interrupt Control Register Ewctl Emac Control Module RegistersAcronym Register Description Bit FieldEmac Control Module Interrupt Timer Count Register Ewinttcnt Mdio Version Register Version Field Descriptions Mdio Version Register VersionManagement Data Input/Output Mdio Registers Mdio Control Register Control Mdio Control Register Control Field DescriptionsPHY Acknowledge Status Register Alive PHY Link Status Register LinkPHY Acknowledge Status Register Alive Field Descriptions PHY Link Status Register Link Field DescriptionsNo Mdio link change event Will clear the event and writing a 0 has no effect No Mdio user command complete event USERINTMASKED0 and USERINTMASKED1 correspond to USERACCESS0 WS-0 Userintmaskclear Mdio User Access Register 0 USERACCESS0 Mdio User Access Register 0 USERACCESS0 Field DescriptionsMdio User PHY Select Register 0 USERPHYSEL0 Linksel LinkintenbPhyadrmon Bit Field Value DescriptionMdio User Access Register 1 USERACCESS1 Mdio User Access Register 1 USERACCESS1 Field DescriptionsMdio User PHY Select Register 1 USERPHYSEL1 Mdio User PHY Select Register 1 USERPHYSEL1Ethernet Media Access Controller Emac Registers Ethernet Media Access Controller Emac Registers Offset Acronym Register DescriptionOffset Acronym Register Description Network Statistics RegistersTransmit Control Register Txcontrol Field Descriptions Transmit Identification and Version Register TxidverTransmit Control Register Txcontrol Txtdnch Transmit Teardown Register TxteardownTransmit Teardown Register Txteardown Field Descriptions Receive Control Register Rxcontrol Field Descriptions Receive Identification and Version Register RxidverReceive Control Register Rxcontrol Rxtdnch Receive Teardown Register RxteardownReceive Teardown Register Rxteardown Field Descriptions Transmit Interrupt Status Unmasked Register Txintstatraw TX7PENDTransmit Interrupt Status Masked Register Txintstatmasked Transmit Interrupt Status Masked Register TxintstatmaskedTransmit Interrupt Mask Set Register Txintmaskset TX7MASKTransmit Interrupt Mask Clear Register Txintmaskclear Transmit Interrupt Mask Clear Register TxintmaskclearMAC Input Vector Register Macinvector MAC Input Vector Register Macinvector Field DescriptionsUserint Linkint Hostpend Statpend Rxpend TxpendReceive Interrupt Status Unmasked Register Rxintstatraw RX7PENDReceive Interrupt Status Masked Register Rxintstatmasked Receive Interrupt Status Masked Register RxintstatmaskedReceive Interrupt Mask Set Register Rxintmaskset RX7MASKReceive Interrupt Mask Clear Register Rxintmaskclear Receive Interrupt Mask Clear Register RxintmaskclearHostpend Statpend MAC Interrupt Status Unmasked Register MacintstatrawMAC Interrupt Status Masked Register Macintstatmasked MAC Interrupt Mask Set Register Macintmaskset MAC Interrupt Mask Clear Register MacintmaskclearHostmask Statmask HostmaskRxpasscrc Rxqosen Rxnochain RxcmfenRxcsfen Rxcefen Rxcafen RxpromchFrames containing errors are filtered Receive multicast channel select Receive Unicast Enable Set Register Rxunicastset RXCH7ENReceive Unicast Clear Register Rxunicastclear Receive Unicast Clear Register RxunicastclearReceive Maximum Length Register Rxmaxlen Field Descriptions Receive Maximum Length Register RxmaxlenReceive Buffer Offset Register Rxbufferoffset Rxfilterthresh Reserved RX nFLOWTHRESH FFhReceive Channel 0-7 Free Buffer Count Register RXnFREEBUFFER MAC Control Register Maccontrol MAC Control Register Maccontrol Field DescriptionsSent. Full-duplex mode no outgoing pause frames are sent LoopbackMAC Status Register Macstatus MAC Status Register Macstatus Field DescriptionsMAC Status Register Macstatus Field Descriptions Bit Field Value DescriptionEmulation Control Register Emcontrol Fifo Control Register FifocontrolEmulation Control Register Emcontrol Field Descriptions Fifo Control Register Fifocontrol Field DescriptionsMAC Configuration Register Macconfig Soft Reset Register SoftresetMAC Configuration Register Macconfig Field Descriptions Soft Reset Register Softreset Field DescriptionsMAC Source Address Low Bytes Register Macsrcaddrlo MAC Source Address High Bytes Register MacsrcaddrhiMAC Hash Address Register 1 MACHASH1 MAC Hash Address Register 2 MACHASH2MAC Hash Address Register 1 MACHASH1 Field Descriptions MAC Hash Address Register 2 MACHASH2 Field DescriptionsBack Off Test Register Bofftest Field Descriptions Back Off Test Register BofftestTransmit Pacing Algorithm Test Register Tpacetest Receive Pause Timer Register Rxpause Transmit Pause Timer Register TxpauseReceive Pause Timer Register Rxpause Field Descriptions Transmit Pause Timer Register Txpause Field DescriptionsMAC Address Low Bytes Register Macaddrlo Field Descriptions MAC Address Low Bytes Register MacaddrloMAC Address High Bytes Register Macaddrhi Macindex MAC Index Register MacindexMAC Index Register Macindex Field Descriptions TX nHDP Transmit Channel 0-7 Completion Pointer Register TXnCP Receive Channel 0-7 Completion Pointer Register RXnCPNetwork Statistics Registers Good Receive Frames Register RxgoodframesBroadcast Receive Frames Register Rxbcastframes Multicast Receive Frames Register RxmcastframesReceive CRC Errors Register Rxcrcerrors Receive Alignment/Code Errors Register RxaligncodeerrorsPause Receive Frames Register Rxpauseframes Receive Oversized Frames Register RxoversizedReceive Jabber Frames Register Rxjabber Receive Undersized Frames Register RxundersizedReceive Frame Fragments Register Rxfragments Filtered Receive Frames Register RxfilteredGood Transmit Frames Register Txgoodframes Receive QOS Filtered Frames Register RxqosfilteredReceive Octet Frames Register Rxoctets Broadcast Transmit Frames Register Txbcastframes Multicast Transmit Frames Register TxmcastframesPause Transmit Frames Register Txpauseframes Deferred Transmit Frames Register TxdeferredTransmit Underrun Error Register Txunderrun Transmit Single Collision Frames Register TxsinglecollTransmit Multiple Collision Frames Register Txmulticoll Transmit Late Collision Frames Register TxlatecollTransmit and Receive 64 Octet Frames Register FRAME64 Transmit Carrier Sense Errors Register TxcarriersenseTransmit Octet Frames Register Txoctets Network Octet Frames Register Netoctets Receive DMA Overruns Register Rxdmaoverruns Appendix a Glossary Table A-1. Physical Layer Definitions Term DefinitionTable B-1. Document Revision History Reference Additions/Modifications/DeletionsProducts Applications DSP

Related manuals

Manual 38 pages 8.14 Kb