2. Installation and connection
Caution (for installation and connection)
Do not install the unit in other than specified orientations.
●Dropping or toppling the unit may cause injury.
●If you install the unit in an orientation other than specified, the unit cannot be protected from a battery fluid leakage.
Do not use the unit where the maximum temperature exceeds 40°C.
●The battery becomes weak rapidly, which may cause a fire.
●Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges specified for environmental conditions during use/storage.
Do not install or store the unit in the places listed below.
●Do not store in places where the humidity is lower than 20% or higher than 90%.
●Do not use in places where the humidity is lower than 25% or higher than 85%.
●Do not use in closed spaces such as cabinets without clearance, or in places where flam- mable or corrosive gases are present, places subject to vibration or shock, or outdoors.
●Installation or storing the unit in such a place may cause a fire.
Do not connect equipment that exceeds the output capacity of the unit. You can use a 200V plug strip to connect additional devices, but do not connect devices that exceed the current capacity of the plug strip.
●The current protection of the unit may operate, which may stop the output.
●The wiring of the plug strip heats up, which may cause a fire.
Do not pinch or tie the cable of the unit.
●Doing so may cause the cable to be damaged or heated, which may cause an electric shock or a fire.
●If the cable is damaged, stop using the unit and have the cable repaired. For repair, contact us; ____
All of the included accessories are designed to be used exclusively with the unit. Do not use the accessories with other devices.
●Doing so may compromise the safety of devices.
●This UPS utilizes voltages that may be hazardous. Do not attempt to disassemble the unit The unit contains no user serviceable parts.Only factory service personnel may perform repairs.
●Connection to any other type of receptacle other than a
●Do not allow liquids or any foreign object to enter the UPS.DO not place beverages or any other
●This unit intended for installation in a controlled environment (temperature controlled, indoor area free of conductive contaminants).Avoid installing the UPS in locations where there is standing or running water,or excessive humidity.
●Do not attach a power strip or surge suppressor to the UPS.
●Do not attach
●With the installation of the equipment it should be prevented, that the sum of the leakage current of the UPS and the connected consumer does not exceed 3.5mA.
18