Omron BU1002SW, BU3002SW specifications Output delay time setting for backup signal output BU

7．Using the UPS monitoring software and contact signal

●Output delay time setting for backup signal output (BU)

Continues during a power failure, and turns ON (OFF). By setting the contact signal card’s setting switch as shown in the table on the right, the length of time from when the power failure occurs until the power failure signal is output can be delayed between 0 and 3 minutes.

The power failure signal is not output if the power supply error is resolved within the set delay time.

●BU/BL signal reverse output setting

BU and BL signals are output in reverse.

BU-COM ON when there is a power failure

	ON
		2	3
	1
Setting	Setting			Delay time
switch 1	switch 2				setting
OFF	OFF	0 second
		(factory setting)
ON	OFF	Signal output after
		30 seconds
OFF	ON	Signal output after
		60 seconds
ON	ON	Signal output after
		180 seconds

ON	2	3
1

AC input	ON
	OFF
BU signal	ON
((setting switch 3:

OFF (normal output)) OFF

BU signal	ON
((setting switch 3:
ON (reverse output))	OFF

Setting switch 3	Backup signal output (BU)
OFF	Normal output (factory setting)
ON	Reverse output

Backup signal output (BU) delay time setting (setting switches 1, 2)

■Jumper settings

By making jumper settings, the contact signal card SC05/06 connector pin assignments can be changed. Turn over the contact signal card, and change all (8) of the jumper settings to "SC05/06".

<Before change>		<After change>
	SC05/06		SC05/06
	SC07		SC07

Jumper settings

(8)

79