Liebert 30-130kVA manual Condition only causes an alarm, but should

Operation

Table 7	Alarms, functions, and corrective actions (continued)
Actual
Alarm/fault
Name
Displayed		Description	Fault
On Front		of Alarm/	Or	Latch	Dial	Freeze	Event Log
Panel		Fault	Alarm	Mask	Mask	Mask	Mask	Meaning and Corrective Action(s)
								With the Batt Gnd Fault option installed and
Batt Gnd		Battery ground	Alarm	NO	YES	NO	YES	the batt breaker closed, the DSP sees its
Fault		fault alarm						BGF input asserted by the SWGR. No
								action required.
Aux Ovtemp		Aux Overtemp						With the Auxiliary temp sensor installed, it
			Alarm	YES	YES	NO	YES	is reading 85% or more of the specified
Warning		Warning
								Maximum Aux temperature set point value.
Batt Ovtemp		Battery						With the battery breaker closed the battery
		Overtemp	Alarm	NO	YES	NO	YES	has exceeded the “Battery Temperature
Warning
		Warning						Alarm Threshold” set point value.
								Sensors on the power semiconductor
								heatsinks detect temperatures above the
								steady state limits for these components.
		Heatsink						The control logic sets off the alarm but does
Heatsink								not shut down the UPS module if the
		Overtemp	Alarm	NO	YES	NO	YES
Ovtemp								condition lasts less than 10 minutes. Check
		Warning
								the air intake, air exhaust, and filters.
								Reduce the load or transfer it to bypass.
								Contact Liebert Global Services if the alarm
								persists.
								The intake air to the UPS module exceeds
		Inlet Air						the specified maximum temperature. This
Inlet Air								condition only causes an alarm, but should
		Overtemp	Alarm	NO	YES	NO	YES	be corrected immediately to prevent
Ovtemp
		Warning						equipment overheating. Check to make
								sure nothing is blocking the inlet air and that
								the air filter is clean.
Ups Ambient		UPS Ambient						The Outlet air temperature has exceeded
			Alarm	NO	YES	NO	YES	85% of its “Maximum outlet air temperature”
OvTemp		OvTemp
								limit.
								A fault in the designated Fan motor has
								occurred. This condition only causes an
								alarm, but if not promptly corrected it could
Pwr pole Fan		Power pole	Alarm	NO	YES	NO	YES	cause an equipment over-temperature
1 Fail		Fan 1 Fail						condition that would shut down the UPS
								Module. Check the Fans for proper
								operation. Contact Liebert Global Services
								if you require assistance or to replace a fan.
								A fault in the designated Fan motor has
								occurred. This condition only causes an
								alarm, but if not promptly corrected it could
Pwr pole Fan		Power pole	Alarm	NO	YES	NO	YES	cause an equipment over-temperature
2 Fail		Fan 2 Fail						condition that would shut down the UPS
								Module. Check the Fans for proper
								operation. Contact Liebert Global Services
								to replace a fan.
								A fault in the designated Fan motor has
								occurred. This condition only causes an
								alarm, but if not promptly corrected it could
Pwr pole Fan		Power pole	Alarm	NO	YES	NO	YES	cause an equipment over-temperature
3 Fail		Fan 3 Fail						condition that would shut down the UPS
								Module. Check the Fans for proper
								operation. Contact Liebert Global Services
								to replace a fan.

84