GE A8950CC installation instructions Connect, Configure

Page 14

2. Connect:

Connect Ethernet-capable equipment directly to the Ethernet module using CAT5 twisted- pair cables with male RJ-45 connectors at both ends. Do not use breakout boxes.

Standard CAT5 cabling used for Ethernet is available with either straight-through or crossover connections. Either variety may be used with the Ethernet module. The auto-MDI/MDI-X feature of each port automatically detects the type of cable connection to establish link.

3. Configure:

At power-up, every port has Auto-Negotiation enabled. This should work seamlessly with most Ethernet equipment. However, if necessary, Auto-Negotiation, Link Speed and Duplex can be configured manually via the Phoenix chassis’s front panel.

Refer to the section Front Panel Menu Tree and Descriptions for more information.

12

Image 14

Contents Installation instructions Installation Instructions Customer Support Before You BeginIntended Use Conventions Used in this ManualGetting Started Installing Power SuppliesModule Installation OverviewTools and materials required Installing the Optical Transceiver ModuleInstallation instructions Connect fiberSelf-Healing Connect Point-to-Point ConnectRepeater Connect LED operating status Optic LEDSetting Mode Installing the Data ModuleConfigure data module Install data module ConnectUsing the breakout box Fiber Link Data ConnectionsPin Signal RS-485 4-WIRE Interface Data module channel sequenceInstalling the Ethernet Module Install the Ethernet moduleConfigure Install video output module Installing the Video ModuleInstall video input module Video Outputs Connection instructionsVideo Inputs Video Input module channel sequence Video Output module channel sequenceInstalling the Audio Module Configure audio moduleInstalling audio modules Channel sequence is as followsConnecting to audio modules Audio module channel sequence Terminal Block Pin AssignmentsInstalling the Contact Closure Module Install contact closure moduleConnect to the module RJ45 Socket Viewed from the rear of the unitContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Turn on power and check status Select the system topologyGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Node Main MenuMain Local Main Local Node ID Main Local Node TopologyMain Local Optics Transmit Main Local Node Load DefaultsMain Local Optics Main Local Optics ReceiveMain Local Video Input Mapping Main Local Optics InfoMain Local Video Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Main Local Data Input MappingMain Local Data Output Mapping Main Local Data Format Select Main Local -Ethernet Port Control Main Local EthernetMain Local Ethernet Port Status Main Local -Ethernet Port TrafficMain Local Audio Output Mapping Main Local AudioMain Local Audio Input Mapping Main Local Contacts Input Mapping Main Local Audio TestMain Local Contacts Main Local Contacts Configure Main Local Contacts Output MappingMain Local Power Main Local TestMain Local Test Video Main Local Test LED/LCD/AlarmMain Local Test Temp Main Local Test DataMain Remote Main AboutBlank Panel Installation and Specifications Overview Limited warrantyOptical Transceiver Module Specifications Product orderingData Module Specifications DataEthernet Module Specifications EthernetVideo Module Specifications VideoAudio Module Specifications Product 0rderingContact Closure Module Specifications Contacts / Relays