GE A8950CC installation instructions Audio module channel sequence, Terminal Block Pin Assignments

Page 21

Figure 1. Terminal Block Pin Assignments

54


6							3

7								2

8								1

Using the breakout box

A breakout box with a 3’ CAT 5 patch cord (supplied) can be used to interface to the Phoenix system. Pinouts are shown in the tables and figures above.

Figure 2. RJ45 Socket

(Viewed from the rear of the unit)

Pin

1 8

RJ45-A

RJ45-B

RJ45-C

RJ45-D

Audio module - channel sequence

	Slot 15	Slot 16	Slot 17	Slot 18
RJ45-A	Ch 1-2 IN	Ch 5-6 IN	Ch 9-10 IN	Ch 13-14 IN

RJ45-B	Ch 3-4 IN	Ch 7-8 IN	Ch 11-12 IN	Ch 15-16 IN

RJ45-C	Ch 1-2 OUT	Ch 5-6 OUT	Ch 9-10 OUT	Ch 13-14 OUT

RJ45-D	Ch 3-4 OUT	Ch 7-8 OUT	Ch 11-12 OUT	Ch 15-16 OUT

19

Image 21

Contents Installation instructions Installation Instructions Intended Use Before You BeginCustomer Support Conventions Used in this ManualModule Installation Installing Power SuppliesGetting Started OverviewInstallation instructions Installing the Optical Transceiver ModuleTools and materials required Connect fiberPoint-to-Point Connect Repeater ConnectSelf-Healing Connect Optic LED LED operating statusInstalling the Data Module Configure data moduleSetting Mode Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Installing the Video Module Install video input moduleInstall video output module Connection instructions Video InputsVideo Outputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Menu Main LocalMain Local Node Main Local Node Topology Main Local Node IDMain Local Optics Main Local Node Load DefaultsMain Local Optics Transmit Main Local Optics ReceiveMain Local Optics Info Main Local VideoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Port Status Main Local EthernetMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Main Local Audio Input MappingMain Local Audio Output Mapping Main Local Audio Test Main Local ContactsMain Local Contacts Input Mapping Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Temp Main Local Test LED/LCD/AlarmMain Local Test Video Main Local Test DataMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications