GE A8950CC Main Local Audio Input Mapping, Main Local Audio Output Mapping

Page 40

Main -> Local -> Audio:

Audio Menu

1. Input Mapping

2.Output Mapping

3.Test Select

Audio Input and Audio Output mapping and tests can be accessed from the sub-menus.

Main -> Local -> Audio -> Input Mapping:

Audio

	A
Exit 1	1	1

This screen allows you to assign an audio input channel to an audio output channel over a selected fiber port. The number under the microphone icon indicates the currently selected input channel. The numbers under the speaker icons to the left and/or right of the microphone represent the output channel numbers. The arrows to the left and/or right of the microphone (labeled A and B, respectively) indicate over which fibers this mapping is enabled. If the selected input channel is mapped to the output channel then three lines are displayed radiating out of the speaker icon and the arrow is displayed. If a mapping does not exist for this input and output channel pair, then the lines next to speaker and the arrow are not displayed.

Please refer to the Video Input Mapping Menu described earlier for important notes regarding channel mapping and instructions on how to enable mappings.

Main -> Local -> Audio -> Output Mapping:

Audio
Exit A	1	B

This screen allows you to select which optic port is being reviewed for each of the 16 audio output channels. The number under the speaker icon indicates which audio channel is selected. The letters under the microphone icons indicate at which optic port the selected output channel will be looking. Arrows to the left and right of the speaker icon indicate that the mapping is enabled. If the output channel is not mapped to a fiber then the corresponding arrow is not shown.

Please refer to the Video Output Mapping Menu described earlier for important notes regarding channel mapping and instructions on how to enable mappings.

38

Image 40

Contents Installation instructions Installation Instructions Before You Begin Intended UseCustomer Support Conventions Used in this ManualInstalling Power Supplies Module InstallationGetting Started OverviewInstalling the Optical Transceiver Module Installation instructionsTools and materials required Connect fiberRepeater Connect Point-to-Point ConnectSelf-Healing Connect LED operating status Optic LEDConfigure data module Installing the Data ModuleSetting Mode Install data module ConnectUsing the breakout box Fiber Link Data ConnectionsPin Signal RS-485 4-WIRE Interface Data module channel sequenceInstalling the Ethernet Module Install the Ethernet moduleConfigure Install video input module Installing the Video ModuleInstall video output module Video Inputs Connection instructionsVideo Outputs Video Input module channel sequence Video Output module channel sequenceInstalling the Audio Module Configure audio moduleInstalling audio modules Channel sequence is as followsConnecting to audio modules Audio module channel sequence Terminal Block Pin AssignmentsInstalling the Contact Closure Module Install contact closure moduleConnect to the module RJ45 Socket Viewed from the rear of the unitContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Turn on power and check status Select the system topologyGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Main MenuMain Local Node Main Local Node ID Main Local Node TopologyMain Local Node Load Defaults Main Local OpticsMain Local Optics Transmit Main Local Optics ReceiveMain Local Video Main Local Optics InfoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Main Local Data Input MappingMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Main Local Ethernet Port StatusMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Input Mapping Main Local AudioMain Local Audio Output Mapping Main Local Contacts Main Local Audio TestMain Local Contacts Input Mapping Main Local Contacts Configure Main Local Contacts Output MappingMain Local Power Main Local TestMain Local Test LED/LCD/Alarm Main Local Test TempMain Local Test Video Main Local Test DataMain Remote Main AboutBlank Panel Installation and Specifications Overview Limited warrantyOptical Transceiver Module Specifications Product orderingData Module Specifications DataEthernet Module Specifications EthernetVideo Module Specifications VideoAudio Module Specifications Product 0rderingContact Closure Module Specifications Contacts / Relays