GE A8950CC installation instructions Install data module, Connect

Page 9

2. Install data module:

Up to four data modules can be installed in the Phoenix node. From left, locate and insert data modules into slot 1, 2, 3, or 4 (color-keyed red) and secure.

INSERT DATA CARDS IN SLOTS 1-4 (Red)

3. Connect:

Each data module is shipped with (four) RJ45 cables and (four) breakout boxes to aid in connecting to the Phoenix. Use the tables below to determine pinout information for your application. GE Security recommends using shielded cable for all single ended applications and twisted shielded cable for all differential formats. Wire gauge is dependent on copper run length. Refer to manufacturer of data equipment for specific recommendations. Once the data equipment has been connected, confirmation of data activity can be verified on the front panel LCD.

The channel order is sequential, beginning with the top RJ45 in slot 1 as Channel 1, working vertically such that the bottom RJ45 in slot 1 is Channel 4, and the top RJ45 in slot 2 is Channel 5. This continues to the bottom RJ45 in slot 4, which is mapped to Channel 16.

7

Image 9

Contents Installation instructions Installation Instructions Intended Use Before You BeginCustomer Support Conventions Used in this ManualModule Installation Installing Power SuppliesGetting Started OverviewInstallation instructions Installing the Optical Transceiver ModuleTools and materials required Connect fiberPoint-to-Point Connect Repeater ConnectSelf-Healing Connect Optic LED LED operating statusInstalling the Data Module Configure data moduleSetting Mode Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Installing the Video Module Install video input moduleInstall video output module Connection instructions Video InputsVideo Outputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Menu Main LocalMain Local Node Main Local Node Topology Main Local Node IDMain Local Optics Main Local Node Load DefaultsMain Local Optics Transmit Main Local Optics ReceiveMain Local Optics Info Main Local VideoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Port Status Main Local EthernetMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Main Local Audio Input MappingMain Local Audio Output Mapping Main Local Audio Test Main Local ContactsMain Local Contacts Input Mapping Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Temp Main Local Test LED/LCD/AlarmMain Local Test Video Main Local Test DataMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications