GE A8950CC installation instructions Connection instructions, Video Inputs, Video Outputs

Page 16

Connection instructions

Video Inputs:

Connect video source equipment such as cameras or matrix switcher outputs to the video input modules using the BNCs on the back of the panel. Confirmation of video presence can be confirmed on the front panel LCD. The channel order is sequential, beginning with the top BNC in slot 5 as Channel 1, working vertically such that the bottom BNC in slot 5 is assigned Channel 4, and the top BNC in slot 6 is

assigned Channel 5. This continues to the bottom BNC in slot 8, which is mapped to Channel 16.

Video Outputs:

Connect video monitoring equipment including monitors and recording devices, to the video output cards using the BNCs on the back of the panel. Confirmation of video output can be confirmed on the front panel LCD. As with the inputs cards, the channel order is sequential, beginning with the top BNC in slot 11 as Channel 1, working vertically such that the bottom BNC in slot 11 is assigned Channel 4, and the top BNC in slot 12 is assigned Channel 5. This continues to the bottom BNC in slot 14, which is Channel 16.

14

Image 16

Contents Installation instructions Installation Instructions Before You Begin Intended UseCustomer Support Conventions Used in this ManualInstalling Power Supplies Module InstallationGetting Started OverviewInstalling the Optical Transceiver Module Installation instructionsTools and materials required Connect fiberRepeater Connect Point-to-Point ConnectSelf-Healing Connect LED operating status Optic LEDConfigure data module Installing the Data ModuleSetting Mode Install data module ConnectUsing the breakout box Fiber Link Data ConnectionsPin Signal RS-485 4-WIRE Interface Data module channel sequenceInstalling the Ethernet Module Install the Ethernet moduleConfigure Install video input module Installing the Video ModuleInstall video output module Video Inputs Connection instructionsVideo Outputs Video Input module channel sequence Video Output module channel sequenceInstalling the Audio Module Configure audio moduleInstalling audio modules Channel sequence is as followsConnecting to audio modules Audio module channel sequence Terminal Block Pin AssignmentsInstalling the Contact Closure Module Install contact closure moduleConnect to the module RJ45 Socket Viewed from the rear of the unitContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Turn on power and check status Select the system topologyGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Main MenuMain Local Node Main Local Node ID Main Local Node TopologyMain Local Node Load Defaults Main Local OpticsMain Local Optics Transmit Main Local Optics ReceiveMain Local Video Main Local Optics InfoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Main Local Data Input MappingMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Main Local Ethernet Port StatusMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Input Mapping Main Local AudioMain Local Audio Output Mapping Main Local Contacts Main Local Audio TestMain Local Contacts Input Mapping Main Local Contacts Configure Main Local Contacts Output MappingMain Local Power Main Local TestMain Local Test LED/LCD/Alarm Main Local Test TempMain Local Test Video Main Local Test DataMain Remote Main AboutBlank Panel Installation and Specifications Overview Limited warrantyOptical Transceiver Module Specifications Product orderingData Module Specifications DataEthernet Module Specifications EthernetVideo Module Specifications VideoAudio Module Specifications Product 0rderingContact Closure Module Specifications Contacts / Relays