GE A8950CC installation instructions GE Security

Page 27

The topology and node ID are set using the front panel LCD display. The LCD displays a menu from which sub-menus or features can be selected. The push buttons allow you to navigate through the menus. A small black arrow is used as a cursor. The "up" and "down" buttons move the cursor up or down one line in the menu, respectively. The "enter" button selects the sub-menu or feature at which the cursor is pointing. The "left" button takes you back up one level in the menu hierarchy. The remaining three buttons, "right", "+", and "-" are menu-specific and are described later.

A brief initialization routine is displayed on the LCD when the chassis powers up. A splash screen showing the GE logo and Phoenix product name is displayed after the routine completes. After approximately one minute of inactivity the LCD display will turn off. The display can be re-enabled by pressing any of the seven buttons on the front panel.

GE SECURITY

Phoenix

If the splash screen is displayed or if the display is blank press the "enter" button one time. This will bring up the Main Menu. If any other menu is displayed, then press the "left" button until the Main Menu is shown:

Main Menu

1. Local

2.Remote

3.About

Use the "up" and "down" buttons to move the cursor to "1. Local".

Press the "enter" key to select the Local Menu:

Local Menu

1. Node: 0 - Linear

2.Optics AB

3.Video 1/0 - 4/0

25

Image 27

Contents Installation instructions Installation Instructions Conventions Used in this Manual Before You BeginIntended Use Customer SupportOverview Installing Power SuppliesModule Installation Getting StartedConnect fiber Installing the Optical Transceiver ModuleInstallation instructions Tools and materials requiredPoint-to-Point Connect Repeater ConnectSelf-Healing Connect Optic LED LED operating statusInstalling the Data Module Configure data moduleSetting Mode Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Installing the Video Module Install video input moduleInstall video output module Connection instructions Video InputsVideo Outputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Menu Main LocalMain Local Node Main Local Node Topology Main Local Node IDMain Local Optics Receive Main Local Node Load DefaultsMain Local Optics Main Local Optics TransmitMain Local Optics Info Main Local VideoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local -Ethernet Port Traffic Main Local EthernetMain Local Ethernet Port Status Main Local -Ethernet Port ControlMain Local Audio Main Local Audio Input MappingMain Local Audio Output Mapping Main Local Audio Test Main Local ContactsMain Local Contacts Input Mapping Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Data Main Local Test LED/LCD/AlarmMain Local Test Temp Main Local Test VideoMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications