GE A8950CC installation instructions LED operating status, Optic LED

Page 7

3.Verify fiber connectivity:

Using the LEDs on the back of the unit adjacent to the optic module, verify proper operation as shown in the table below. Both optical launch power and optical receive power, as well as transceiver status, can be verified from the LCD front panel.

LED operating status

Optic LED

		RED	Indicates faulty LASER or no module installed
	Tx
	Tx	OFF	LASER operating within specifications
		OFF	LASER operating within specifications

		GREEN	Indicates sufficient power received and frame synchronization
	Rx
	Rx	OFF	Indicates insufficient optical power
		OFF	Indicates insufficient optical power

5

Image 7

Contents Installation instructions Installation Instructions Conventions Used in this Manual Before You BeginIntended Use Customer SupportOverview Installing Power SuppliesModule Installation Getting StartedConnect fiber Installing the Optical Transceiver ModuleInstallation instructions Tools and materials requiredRepeater Connect Point-to-Point ConnectSelf-Healing Connect Optic LED LED operating statusConfigure data module Installing the Data ModuleSetting Mode Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Install video input module Installing the Video ModuleInstall video output module Video Inputs Connection instructionsVideo Outputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Main MenuMain Local Node Main Local Node Topology Main Local Node IDMain Local Optics Receive Main Local Node Load DefaultsMain Local Optics Main Local Optics TransmitMain Local Video Main Local Optics InfoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local -Ethernet Port Traffic Main Local EthernetMain Local Ethernet Port Status Main Local -Ethernet Port ControlMain Local Audio Input Mapping Main Local AudioMain Local Audio Output Mapping Main Local Contacts Main Local Audio TestMain Local Contacts Input Mapping Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Data Main Local Test LED/LCD/AlarmMain Local Test Temp Main Local Test VideoMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications