GE A8950CC installation instructions Front Panel Menu Tree and Descriptions

Page 29

FRONT PANEL MENU TREE AND DESCRIPTIONS

The menus accessible from the front panel are shown in the menu tree below:

Navigating through the menu tree is accomplished using the push buttons and LCD display. The LCD shows menus from which sub-menus or features can be selected.

A small black arrow is used as a cursor. The "up" and "down" buttons move the cursor up or down one line in the menu, respectively. The "enter" button selects the sub-menu or feature at which the cursor is pointing. The "left" button takes you back up one level in the menu hierarchy. The remaining three buttons, "right", "+", and "-" are menu-specific and are described later.

27

Image 29

Contents Installation instructions Installation Instructions Intended Use Before You BeginCustomer Support Conventions Used in this ManualModule Installation Installing Power SuppliesGetting Started OverviewInstallation instructions Installing the Optical Transceiver ModuleTools and materials required Connect fiberSelf-Healing Connect Point-to-Point ConnectRepeater Connect Optic LED LED operating statusSetting Mode Installing the Data ModuleConfigure data module Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Install video output module Installing the Video ModuleInstall video input module Video Outputs Connection instructionsVideo Inputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Node Main MenuMain Local Main Local Node Topology Main Local Node IDMain Local Optics Main Local Node Load DefaultsMain Local Optics Transmit Main Local Optics ReceiveMain Local Video Input Mapping Main Local Optics InfoMain Local Video Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Port Status Main Local EthernetMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Output Mapping Main Local AudioMain Local Audio Input Mapping Main Local Contacts Input Mapping Main Local Audio TestMain Local Contacts Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Temp Main Local Test LED/LCD/AlarmMain Local Test Video Main Local Test DataMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications