GE A8950CC Main Local Test LED/LCD/Alarm, Main Local Test Temp, Main Local Test Video

Page 44

Main -> Local -> Test -> LED/LCD/Alarm:

This selection runs through a series of three tests:

1.LED Test: All LEDs turn off, then turn green, and then turn red.

2.LCD Test: The screen turns black. Then the GE logo is displayed.

3.Alarm Test: The front panel alarm sounds for a few seconds.

Main -> Local -> Test -> Temp:

This selection displays the temperature of inside optic transceiver A.

Main -> Local -> Test -> Video:

This menu is identical to the Main -> Local -> Video -> Test Menu, described earlier.

Main -> Local -> Test -> Data:

This menu is identical to the Main -> Local -> Data -> Format Menu, described earlier.

Main -> Local -> Test -> Audio:

This menu is identical to the Main -> Local -> Audio -> Test Menu, described earlier.

Main -> Local -> Test -> Contact:

This menu is identical to the Main -> Local -> Contact -> Configure Menu, described earlier in this section.

Main -> Local -> About:

About Menu:

1	Data	3
Slot	Card Type	Rev

The Local About Menu displays the software version for each module installed in the chassis. Press "+" to view the next slot. Press "-" to view the previous slot.

42

Image 44

Contents Installation instructions Installation Instructions Before You Begin Intended UseCustomer Support Conventions Used in this ManualInstalling Power Supplies Module InstallationGetting Started OverviewInstalling the Optical Transceiver Module Installation instructionsTools and materials required Connect fiberSelf-Healing Connect Point-to-Point ConnectRepeater Connect LED operating status Optic LEDSetting Mode Installing the Data ModuleConfigure data module Install data module ConnectUsing the breakout box Fiber Link Data ConnectionsPin Signal RS-485 4-WIRE Interface Data module channel sequenceInstalling the Ethernet Module Install the Ethernet moduleConfigure Install video output module Installing the Video ModuleInstall video input module Video Outputs Connection instructionsVideo Inputs Video Input module channel sequence Video Output module channel sequenceInstalling the Audio Module Configure audio moduleInstalling audio modules Channel sequence is as followsConnecting to audio modules Audio module channel sequence Terminal Block Pin AssignmentsInstalling the Contact Closure Module Install contact closure moduleConnect to the module RJ45 Socket Viewed from the rear of the unitContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Turn on power and check status Select the system topologyGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Node Main MenuMain Local Main Local Node ID Main Local Node TopologyMain Local Node Load Defaults Main Local OpticsMain Local Optics Transmit Main Local Optics ReceiveMain Local Video Input Mapping Main Local Optics InfoMain Local Video Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Main Local Data Input MappingMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Main Local Ethernet Port StatusMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Output Mapping Main Local AudioMain Local Audio Input Mapping Main Local Contacts Input Mapping Main Local Audio TestMain Local Contacts Main Local Contacts Configure Main Local Contacts Output MappingMain Local Power Main Local TestMain Local Test LED/LCD/Alarm Main Local Test TempMain Local Test Video Main Local Test DataMain Remote Main AboutBlank Panel Installation and Specifications Overview Limited warrantyOptical Transceiver Module Specifications Product orderingData Module Specifications DataEthernet Module Specifications EthernetVideo Module Specifications VideoAudio Module Specifications Product 0rderingContact Closure Module Specifications Contacts / Relays