GE A8950CC installation instructions Main Local Power, Main Local Test

Page 43

The third line, "2. Type" allows system events to be mapped to contact closure output channels:

•Transmitted. The contact behaves normally.

•Optic A: A problem on optic port A closes the selected contact.

•Optic B: A problem on optic port B closes the selected contact.

•Optic A or B: A problem on either optic port closes the selected contact.

•Video X: Loss of video on the specified video input channel

(where X is the video channel) closes the selected contact.

•Video W,X,Y,Z: Loss of video on any of the specified video input channels (where W,X,Y,Z are the video channels) closes the selected contact.

The fourth line, "3. Force" allows a contact output to be forced into a known state for test:

•None: The test is disabled and the contact behaves normally.

•Open: The contact is forced open.

•Closed: The contact is forced closed.

When leaving this menu with test patterns enabled, a warning message comes up alerting that the test states have been disabled to allow real contact closure information to pass.

Main -> Local -> Power:

Power Supply: A B Pass

+5V 5.2

-5V -4.9

+12V

11.9

-12V -12.3

This menu displays the measured voltages of the selected power supply. It also indicates the status of the power supply (Pass/ Fail). Use "+" to select the next power supply. Use "- " to select the previous power supply. Press "left" to exit this menu.

Main -> Local -> Test:

Test Menu

1. LED/LCD/Alarm

2.Temp

3.Video

Various tests can be selected from the sub-menus.

41

Image 43

Contents Installation instructions Installation Instructions Conventions Used in this Manual Before You BeginIntended Use Customer SupportOverview Installing Power SuppliesModule Installation Getting StartedConnect fiber Installing the Optical Transceiver ModuleInstallation instructions Tools and materials requiredRepeater Connect Point-to-Point ConnectSelf-Healing Connect Optic LED LED operating statusConfigure data module Installing the Data ModuleSetting Mode Connect Install data moduleFiber Link Data Connections Using the breakout boxPin Signal Data module channel sequence RS-485 4-WIRE InterfaceInstall the Ethernet module Installing the Ethernet ModuleConfigure Install video input module Installing the Video ModuleInstall video output module Video Inputs Connection instructionsVideo Outputs Video Output module channel sequence Video Input module channel sequenceConfigure audio module Installing the Audio ModuleChannel sequence is as follows Installing audio modulesConnecting to audio modules Terminal Block Pin Assignments Audio module channel sequenceInstall contact closure module Installing the Contact Closure ModuleRJ45 Socket Viewed from the rear of the unit Connect to the moduleContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Select the system topology Turn on power and check statusGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Main MenuMain Local Node Main Local Node Topology Main Local Node IDMain Local Optics Receive Main Local Node Load DefaultsMain Local Optics Main Local Optics TransmitMain Local Video Main Local Optics InfoMain Local Video Input Mapping Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Input Mapping Main Local DataMain Local Data Output Mapping Main Local Data Format Select Main Local -Ethernet Port Traffic Main Local EthernetMain Local Ethernet Port Status Main Local -Ethernet Port ControlMain Local Audio Input Mapping Main Local AudioMain Local Audio Output Mapping Main Local Contacts Main Local Audio TestMain Local Contacts Input Mapping Main Local Contacts Output Mapping Main Local Contacts ConfigureMain Local Test Main Local PowerMain Local Test Data Main Local Test LED/LCD/AlarmMain Local Test Temp Main Local Test VideoMain About Main RemoteOverview Limited warranty Blank Panel Installation and SpecificationsProduct ordering Optical Transceiver Module SpecificationsData Data Module SpecificationsEthernet Ethernet Module SpecificationsVideo Video Module SpecificationsProduct 0rdering Audio Module SpecificationsContacts / Relays Contact Closure Module Specifications