GE A8950CC installation instructions Main Local Node Load Defaults, Main Local Optics Transmit

Page 32

Main -> Local -> Node -> Load Defaults

This feature sets the node ID back to zero and clears all channel mapping information for this node. The topology is retained.

Main -> Local -> Optics:

Optic Menu

1. Transmit

2.Receive

3.Info

Information about the fiber optic transceivers can be accessed from the sub-menus.

Main -> Local -> Optics -> Transmit:

Tx Optic A B C D

4.23 mW

Status: Good

This screen shows the optical launch power of the selected optic transceiver. Use the "+" button to select the next transceiver. Use the "-" button to select the previous transceiver.

The launch power is displayed in milliwatts (mW). Values around +4mW are normal. Additionally, the transceiver transmit (TX) status is displayed. The status is reported as either Good, Faulty, or Not Found if the selected transceiver is not installed.

Main -> Local -> Optics -> Receive:

Rx Optic: ABCD

3.97mW

Status: Good

This screen shows the optical receive power of the selected optic transceiver. Use the "+" button to select the next transceiver. Use the "-" button to select the previous transceiver.

The power is displayed in milliwatts (mW). The receive power can be used to verify path loss if the transmit launch power at the other end of a fiber is known. Sensitivity must be greater than 0.04 mW to insure enough optical power is being received. Additionally, the transceiver receive (RX) status is displayed. The status is reported as Good, Sync Loss, Signal Loss or Not Found if the selected transceiver is not installed.

30

Image 32

Contents Installation instructions Installation Instructions Before You Begin Intended UseCustomer Support Conventions Used in this ManualInstalling Power Supplies Module InstallationGetting Started OverviewInstalling the Optical Transceiver Module Installation instructionsTools and materials required Connect fiberSelf-Healing Connect Point-to-Point ConnectRepeater Connect LED operating status Optic LEDSetting Mode Installing the Data ModuleConfigure data module Install data module ConnectUsing the breakout box Fiber Link Data ConnectionsPin Signal RS-485 4-WIRE Interface Data module channel sequenceInstalling the Ethernet Module Install the Ethernet moduleConfigure Install video output module Installing the Video ModuleInstall video input module Video Outputs Connection instructionsVideo Inputs Video Input module channel sequence Video Output module channel sequenceInstalling the Audio Module Configure audio moduleInstalling audio modules Channel sequence is as followsConnecting to audio modules Audio module channel sequence Terminal Block Pin AssignmentsInstalling the Contact Closure Module Install contact closure moduleConnect to the module RJ45 Socket Viewed from the rear of the unitContact Input module channel sequence Configuring the Phoenix Fiber Optic Communications System Turn on power and check status Select the system topologyGE Security Set the Node ID Front Panel Menu Tree and Descriptions Main Local Node Main MenuMain Local Main Local Node ID Main Local Node TopologyMain Local Node Load Defaults Main Local OpticsMain Local Optics Transmit Main Local Optics ReceiveMain Local Video Input Mapping Main Local Optics InfoMain Local Video Main Local Video Output Mapping Video Test Channel Test Off Format Ntsc Main Local Data Main Local Data Input MappingMain Local Data Output Mapping Main Local Data Format Select Main Local Ethernet Main Local Ethernet Port StatusMain Local -Ethernet Port Control Main Local -Ethernet Port TrafficMain Local Audio Output Mapping Main Local AudioMain Local Audio Input Mapping Main Local Contacts Input Mapping Main Local Audio TestMain Local Contacts Main Local Contacts Configure Main Local Contacts Output MappingMain Local Power Main Local TestMain Local Test LED/LCD/Alarm Main Local Test TempMain Local Test Video Main Local Test DataMain Remote Main AboutBlank Panel Installation and Specifications Overview Limited warrantyOptical Transceiver Module Specifications Product orderingData Module Specifications DataEthernet Module Specifications EthernetVideo Module Specifications VideoAudio Module Specifications Product 0rderingContact Closure Module Specifications Contacts / Relays