Falcon XG2.2K-1T, XG1.5K-1T, XG3K-1T Mounting feet Mounting feet for additional Battery Modules

Page 10

Mounting feet

Mounting feet for additional Battery

 

Modules

XG1.5K-1T Free Standing

XG2.2K-1T / XG3K-1T Free Stranding

The default LCD display mounting is for horizontal (Rackmount) viewing. To orient the LCD display for vertical (Mini-Tower) viewing, remove the front plastic bezel by unscrewing the screws. The unit has two front panel covers. Remove the left cover first. Next, pull the right panel forward evenly. Refer to the following figure, unscrew the LCD board and rotate it 90 degrees, to the correct position for viewing. Mount the front covers back and reinstall the screws.

10

Image 10
Contents Owners Operating Manual Table of Contents Battery InstallationStorage and Transportation Introduction Block Diagram Circuit DescriptionsInstallation FREE-STANDING UPS Installation RACK-MOUNT UPS SetupInspecting the Equipment Page FREE-STANDING UPS Installation Mounting feet Mounting feet for additional Battery Modules Battery Module Installation Display & Controls SET/ALARM Silence BypassFUNCTION/TEST Indicators and Icons Located on the LCD Display Controls FUNCTION/TEST ButtonOperation Normal ON-LINE ModeBattery Mode Operating ModesGreen Mode Bypass ModeTurning the UPS on Green Mode Function BIT UPS Setup ConfigurationHow To Place The UPS Into Setup/CONFIGURATION Mode Turning the UPS OFFHow to Set the UPS Output Voltage How to Enable or Disable Green ModeConfiguration Mode An Example of How to Set the UPS Output Voltage to 115Vac CommunicationsRS-232 Port PIN #Standard Dry Contact Interface Card Novell style UA88374 Relay Option BoardWhen to Replace Batteries MaintenanceUPS and Battery Care Battery Pack ReplacementInternal Battery Pack Replacement Testing NEW Batteries Recycling the Used BatteryFuse Replacement Troubleshooting Troubleshooting GuideTroubleshooting Guide UPSInternal Battery Pack DimensionsWeight InputModel Number XG2.2K-1T Battery RUN Times Warranty General Provisions