Falcon XG1.5K-1T, XG2.2K-1T, XG3K-1T Display & Controls, Function/Test, SET/ALARM Silence Bypass

Page 12

4.Connect the supplied battery modules cable to the rear of the extended battery module, then to the rear of the UPS.

5.Turn on the battery breaker on the rear of the extended battery module.

6.If an extended battery module has been connected, refer to the Battery Run Time charts in this manual for the approximate runtime available.

XG2.2K-1T

4.0 DISPLAY & CONTROLS

The diagram below shows the basic functions of the front panel for all the XG Series UPS models.

FUNCTION/TEST

LCD DISPLAY

SET/ALARM SILENCE

BYPASS

INPUT BREAKER

12

Image 12

Contents Owners Operating Manual Table of Contents Installation BatteryStorage and Transportation Introduction Block Diagram Circuit DescriptionsInstallation RACK-MOUNT UPS Setup FREE-STANDING UPS InstallationInspecting the Equipment Page FREE-STANDING UPS Installation Mounting feet Mounting feet for additional Battery Modules Battery Module Installation SET/ALARM Silence Bypass Display & ControlsFUNCTION/TEST Indicators and Icons Located on the LCD Display Controls FUNCTION/TEST ButtonNormal ON-LINE Mode Battery ModeOperation Operating ModesBypass Mode Green ModeTurning the UPS on UPS Setup Configuration How To Place The UPS Into Setup/CONFIGURATION ModeGreen Mode Function BIT Turning the UPS OFFHow to Enable or Disable Green Mode How to Set the UPS Output VoltageConfiguration Mode An Example of How to Set the UPS Output Voltage to 115Vac CommunicationsRS-232 Port PIN #Standard Dry Contact Interface Card Novell style UA88374 Relay Option BoardMaintenance UPS and Battery CareWhen to Replace Batteries Battery Pack ReplacementInternal Battery Pack Replacement Testing NEW Batteries Recycling the Used BatteryFuse Replacement Troubleshooting Troubleshooting GuideTroubleshooting Guide UPSDimensions WeightInternal Battery Pack InputModel Number XG2.2K-1T Battery RUN Times Warranty General Provisions