Freescale Semiconductor MMDS0508 manual Logic Cables and Connectors

Freescale Semiconductor, Inc.

Connector Information

Logic Cables and Connectors

Table 3.1	. Serial Connector and Cable Pin Assignments
Connector Pin		Mnemonic	Signal
1		DCD	DATA CARRIER DETECT — Output signal that
			indicates detection of an acceptable carrier
			signal.
2		RX	RECEIVE DATA — Serial data output line.
3		TX	TRANSMIT DATA — Serial data input line.
4		DTR	DATA TERMINAL READY — Input signal that
			indicates on-line/in-line/active status.
5		GND	GROUND
6		DSR	DATA SET READY — Output signal that
			indicates on-line/in-line service/active status.
7		RTS	REQUEST TO SEND — Input signal that
			requests permission to transfer data.
8		CTS	CLEAR TO SEND — Output signal that indicates
			a ready-to-transfer data status.

3.4 Logic Cables and Connectors

The diagram below shows the pin numbering for both pod A and pod B logic cable connectors. Table 3.2 lists the pin assignments.

19									1
•	•	•	•	•	•	•	•	•	•
•	•	•	•	•	•	•	•	•	•
20									2

3–18 MMDS0508 Target Interface

For More Information: www.freescale.com