Freescale Semiconductor, Inc.
2
Installation
2.1 Introduction
Complete MMDS installation consists of:
•Configuring the platform board,
•Configuring the emulation module (EM),
•Installing the EM, and
•Making system cable connections.
This section explains all items except EM configuration. (As EM configuration is specific to each EM, you must follow the instructions of your EM user's manual.) Additionally, this sections explains how to remove an EM from the station module.
Figure 2.1 shows the right side of the MMDS station module, with the access panel open. Callouts indicate the reset switch and power LED (on the front of the station module), and the logic cable A and B connectors (on the right side of the station module). (Alternate names for the logic cable connectors are pod A and pod B.) If you use logic clip cables, always attach the black clip to ground.
Figure 2.2 shows the left side of the station module, with the access panel closed. Callouts indicate the power cord socket, the power switch, and the 9-pin RS-232 serial connector. The circular, +5 V out connector is reserved for possible future features. (A spacer covers the final enclosure cutout, for a future connector.)
MMDS0508 Target Interface |
For More Information: www.freescale.com