Aiwa LCX=300, LCX-301 manual Clock, Press the II SET button, Down

		SETTING		THE CLOCK
		When the AC cord is just connected, the clock display flashes.
		Set the time as follows while the power is off.
		1 Press the II SET button.
		The hour flashes.
		2 Press	the	W	DOWN	or UP	M	button	to
		designate		the	hour.
		3 Press the II SET button to set the hour.
		The hour stops flashing and the minute starts flashing.
		4 Press	the	W	DOWN	or UP	M	button	to
		designate		the	minute.
		5 Press the II SET button to set the minute and
		complete setting.
		The minute stops flashing on the display and the clock starts
		from 00 second.
		To correct the current time
		Press the POWER button to turn the unit off. Press the II SET
		button, the clock display flashes and carry out steps 1 to 5 above.
2	144DOWN UP W	To display the current time
		Press the	CLOCK button while			pressing	the	SHIFT button	on

the remote control. The clock is displayed for 4 seconds. However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press the CLOCK button while pressing the SHIFT button on the remote control and then press the ■ button within 4 seconds. Repeat the same procedure to restore the 12-hour standard.

if the clock display flashes while the power is off

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

144 DOWN UP -

w

b

14