TROUBLESHOOTING GUIDE
Iftheunit fails toperform as described in these operating instructions, check the following guide.
GENERAL
There is no sound.
●Is the AC cord connected properly?
● 1s there a bad connection? (+ page 10)
●There may be a short circuit in the speaker terminals.
+Disconnect the AC cord, then correct the speaker connections.
●Was an incorrect function button pressed?
Sound is emitted from one speaker only.
● Is the other speaker disconnected? (+ page 10)
TUNER SECTION
There is constant, wave-like static.
● Is the antenna connected properly? (+ page 10)
●Is the signal weak?
+Install an outdoor antenna. (+ page 10)
The reception contains noise interferences or the sound is
distorted.
●Is the system picking up external noise or multipath distortion?
+Change the orientation of the antenna. (+ page 8)
+Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
●Is the deck in pause mode? (+ page 28)
The sound is
●Is the playback head dirty? (+ page 36)
Recording is not possible.
●Is the erasure prevention tab on the tape broken off? (+ page 28)
●Is the recording head dirty? (+ page 36)
High frequency sound is not emitted.
●Is the recording/playback head dirty? (+ page 36)
CD PLAYER SECTION
The CD player does not play.
c Is the disc correctly inserted? (+ page 22)
●Is the disc dirty? (+ page 36)
●Is the lens affected by condensation?
+ Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.
1 Press the POWER button to turn off the power.
2Press the POWER button to turn the power back on while pressing the ■ CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step 2.
40