Datacard Group RL90, RP90 manual Align the end of the supply material with

Laminator error recovery

6Inspect the cartridge:

—If the material on the cartridge is in one piece:

—Turn the cartridge take-up knob counter-clockwise until all damaged material is wound neatly on the take-up spool.

—If the material is split or broken:

—Trim the ends of the broken portions evenly.

—Align the end of the supply material with the

take-up spool and apply tape to secure.

— Turn the material onto the take-up spool until the mended portion is wound two or three turns.

7 Replace the loaded laminator cartridge in the printer until it clicks into position.

8 Close the printer door.

9 Initialize the patch or topcoat material by pressing the laminator’s RESET/K and then the ENTER key.

RP90 Plus E and RL90 User Guide 63