Ultimate Technology 600 POS manual LED 2 turns off

Table 2. Local Mode Programming Instructions

* = Default Settings

Function Code(s)	Operation		Normal Indication		Remarks
02	1.	Swipe Program Card.		While in programming mode, at the Series 600 Keyboard
Code Primary Key		numeric keypad, enter Function Code 02.
Functions to		LED (2) turns on.
Secondary Key	2.	At the Series 600 Keyboard, press the designated key to copy its primary function
Positions
		into the secondary position.
	3.	Repeat 2 for next key to be programmed.
	4.	When completed, press ENTER.
		LED (2) turns off.
	5.	Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.
	Note: A Sec Op Key or Sec Op Lock Key must be programmed in the primary function
	mode in order to use secondary function codes.
03	The keys on the Series 600 Keyboard can be programmed to output unique key codes.
04	These keys are used with the UTC OPOS keyboard driver. These key codes cannot be
	reproduced on a standard keyboard.
Program Primary	1.	Swipe Program	Card.	While in programming mode, at the Series 600 Keyboard
OPOS Keys (03)
		numeric keypad, enter Function Code			03 for primary key or 04 for secondary key
and Secondary
		function.
OPOS Keys (04)
		LED (2) turns on.
	2.	At the Series 600 Keyboard, press the key to be programmed.
		LED (2) flashes.
	3.	On the Series 600 keypad, type the number of the desired OPOS key to be used 01-
		50 and then hit the keypad ENTER on the Series 600 Keyboard.
					If LED (2) stops flashing, repeat
					step 2.
	4.	Repeat 2 and 3 for next key to be programmed.
	5.	Exit programming primary/secondary OPOS key functions by pressing 99 on the
		Series 600 Keyboard numeric pad.

Series 600 POS Keyboard 15