Ultimate Technology 600 POS manual Turns

Table 2. Local Mode Programming Instructions

* = Default Settings

Function Code(s) Operation Normal Indication Remarks

381. Swipe Program Card. While in programming mode, at the Series 600 Keyboard

39	numeric keypad, enter applicable Function Code 38, 39, 40, 21, 42, or 43.
40	LED (2) flashes.
41

422. At the auxiliary keyboard, type the desired MAKE or BREAK key sequence shown

43		below and/or desired key sequence. Note that the maximum number of key codes is
Keyswitch
		limited to 24 – this is equivalent to approximately 12 key strokes.
Position 1
MAKE (38)		If the Series 600 Keyboard beeps and
Keyswitch		LED (2)	turns	off while entering	key
		codes at	the	auxiliary keyboard,	you
Position 1
		have exceeded 24 key codes. Repeat
BREAK (39)
		steps 1 and 2.
Keyswitch
Position 2	3. At the Series 600 Keyboard, press ENTER.
MAKE (40)
		LED (2) turns off.
Keyswitch	4.	Program the next function code or exit programming mode by entering 99 on Series
Position 2
		600 Keyboard numeric keypad or by swiping the Program Card.
BREAK (41)
Keyswitch
Position 3
MAKE (42)
Keyswitch
Position 3
BREAK (43)
44	1.	Swipe Program Card. While in programming mode,	at the Series 600 Keyboard
Poll		numeric keypad, enter Function Code 44.
Keyswitch		LED (2) turns on.
	2. At Series 600 Keyboard numeric keypad, enter the applicable number (0 or 1) to
		select polling method per list below.
		0 = Send on change or transition
		1 = Send only with poll command B7
		LED (2) turns off.
	3. Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.
Series 600 POS Keyboard		23