Ultimate Technology 600 POS manual 24 or, 25 or

Table 2. Local Mode Programming Instructions

* = Default Settings

Function Code(s)	Operation		Normal Indication		Remarks
24 or 34	1.	Swipe	Program Card.	While in programming	mode, at the Series 600 Keyboard
Main Port 0 (24)		numeric keypad, enter Function Code 24 (Port 0) or 34 (Port 1).
AUX Port 1 (34)		LED (2) turns on.
Word Length
	2.	At Series 600 Keyboard numeric keypad, enter the applicable number (7 or 8) to
		select word length per list below.
			7 = 7 data bits
			8 = 8 data bits*
		LED (2) turns off.
	3.	Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.
25 or 35	1.	Swipe	Program Card.	While in programming	mode, at the Series 600 Keyboard
Comm (RS232)		numeric keypad, enter Function Code 25 (Port 0) or 35 (Port 1).
Main Port 0 (25)		LED (2) flashes.
AUX Port 1 (35)
Prefix	2.	At the auxiliary keyboard, press the desired key or type the desired key sequence.
		Note that the maximum number of key codes is limited to 24 – this is equivalent to
		approximately 12 key strokes.
					If the Series 600 Keyboard beeps and
					LED (2) turns off while entering key
					codes at the auxiliary keyboard, you
					have exceeded 24 key codes.
					Repeat steps 1 and 2.
	3.	At the Series 600 Keyboard, press ENTER.
		LED (2) turns off.
	4.	Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.

Series 600 POS Keyboard 21