Ultimate Technology 600 POS manual Commp Command

Table 5. Remote Programming Mode Commands

OP CODE	MNEMONIC/DESCRIPTION		COMMAND/ACKNOWLEDGEMENT
(HEX)
A2	SNDDLY	COMMAND:		A2CxDx<CR>
	Determines rate of delay in milliseconds	A2	= Op Code
	for sending macros. This command used	Cx	= hex value for low nibble
	when interfacing with slow systems.	Dx	= hex value for high nibble
			Range = 00 - FF; Where 00 is no delay
			and each increment in
			count equals 10 mS
		<CR>	= terminate command (0D hex)
		ACKNOWLEDGEMENT: NONE
A3	COMMP	COMMAND:		A3Pbbbbbwsph<CR>
	Communications setup for selecting ports,	A3	= Op Code
	baud rate, word length, stop bits, parity,	P	= destination port for load
	and method of handshaking.	bbbbb	= baud rate
		W	= word length 7 or 8 bits
		s	= number of stop bits 1 or 2
		p	= parity odd, even, or none
		h	= handshaking
		<CR>	= terminate command (0D hex)
		Port:
			0 = main; 1 = AUX
		Baud rate:
			00300, 00600, 01200,
			02400, 04800, 09600,
			19200, 38400, 57600
		Word length:
			7 or 8
		Stop bits:
			1 or 2
		Parity:
			O = odd, E = even, N = none
		Handshaking:
			H = CTS/RTS, S = XON/XOFF,
			B = both, N = none
		ACKNOWLEDGEMENT: NONE

Series 600 POS Keyboard 43