Ultimate Technology 600 POS manual List below to select MSR data from one or both good tracks

Table 2. Local Mode Programming Instructions

* = Default Settings

Function Code(s)	Operation		Normal Indication		Remarks
17	1.	Swipe	Program Card.	While in programming mode,	at the Series 600 Keyboard
18		numeric keypad, enter applicable Function Code 17, or 18.
Magnetic Stripe		LED (2) flashes.
Reader (MSR)	2.	At the auxiliary keyboard, press the desired key or type the desired key sequence.
Track 1,3
		Note that the maximum number of key codes is limited to 24 – this is equivalent to
Bad Read (17)
		approximately 12 key strokes.
Track 2				If the Series 600 Keyboard beeps and
Bad Read
				LED (2)	turns off while entering key
Macro (18)
				codes at the auxiliary keyboard, you
				have exceeded 24 key codes. Repeat
				steps 1 and 2.
	3.	At the Series 600 Keyboard, press ENTER.
		LED (2) turns off.
	4.	Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.
19	1.	Swipe	Program Card.	While in programming mode,	at the Series 600 Keyboard
		numeric keypad, enter Function Code 19.
MSR Send		LED (2) turns on.
	2.	At the Series 600 Keyboard numeric keypad, enter the applicable number (0 or 1) per
		list below to select MSR data from one or both good tracks.
			0 = send any good track*
			1 = send only if all enabled tracks good
	3.	Program the next function code or exit programming mode by entering 99 on Series
		600 Keyboard numeric keypad or by swiping the Program Card.

Series 600 POS Keyboard 18