Unitech MS860 manual Scanner Parts, Scanner LED

INTRODUCTION

SCANNER PARTS:

Status LED ON / OFF Switch

Buzzer

Charge Contacts

Trigger

Scanner LED

The MS860 has one LED indicator located on the head of the scanner which indicates the operating status of the scanner.

Red LED is ON

When the scanner attempts to read a bar code, the LED will glow red.

Single Green LED Flash

When the scanner successfully reads a bar code the scanner LED flashes green once, and you will hear a single beep.

Flashing Green LED

When1. Whenthethescanner readsaa`start‘startconfiguration'configuration’bar codebar (“Entcoder(“EnterGroup 1”,Groupfor 5”,instance)for instance)and entersandconfigurationenters configurationmode, the scannermode,LEDthewillscannerflash greenwillwhileemit the scanner simultaneously gives one High-Low-High tone beep. Upon exiting one high-low-high tone beep and the scanner’s LED will flash green. configuration mode, the scanner will give one High tone beep, and the scanner Upon exiting configuration mode, the scanner will emit one high tone LED will stop flashing.

beep, and the scanner’s LED will stop flashing.

2.The scanner is powered on but not yet connected to the WLAN or the GreenconnectionLEDto thremainsWLAN isONbroken.

z If scans are attempted out of range, communication will be broken,

the scanner LED will remain green, and you will hear continuous Hi-

Green LED remains ON

Low beeps from the scanner when attempting to scan a bar code. When the scanner is powered on and connected to the WLAN successfully.

zThe first time when you establish the communication, the LED will remain green before VCOM communication is established.

	Red LED Flash
	The scanner LED flashing red indicates the scanner has low power
5	and you will need to charge the scanner immediately.
	MS860 WiFi Manual