SPECIFICATIONS
MODEL- PRIME |
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4 
Load Mono
2 
Load Mono
Dimensions: Height
Width
Length
Amplifier Fuse Rating (Amp)
Battery Fuse Rating (Amp) External (Not Supplied)
“A” Weighted Signal to Noise Ratio Referenced to 1 Watt into 4 ohms
“A” Weighted Signal to Noise Ratio Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Remote Punch Level Control (replacement kit)
Protection
320 Watts x 1
500 Watts x 1
2.40" (6.10cm) 7.67" (19.49cm) 16.65" (42.30cm)
(2)30A ATC
60A
≥85 dB
≥105 dB
12dB/octave Butterworth
Low Pass variable from 40Hz to 130Hz
20Hz to 20KHz ±1dB
Variable from 150mV to 8V (RCA Input)
#PLC
Short circuit protection shut downs the amplifier in case of very low impedance or shorted speaker wires.
Punch Bass | Variable from 0dB to +12dB @ 45Hz |
Input Impedance | 20K ohms |
Operating Voltage | 9 to 16 Volts DC |
Balanced Inputs | No |
CMRR (Common Mode Rejection Ratio) | >55dB @ 1KHz |
Damping Factor | >200 |
THD+N (Total Harmonic Distortion + Noise) | < 1.0% @ 4 ohm |
* These specifications are
Specifications subject to change without notice
10