MGE UPS Systems 40-150kVA Graphical User, Interface Display, Emergency Power Off, Fault LED

Page 36

Comet 40-150kVA

Graphical User

This display provides specific information concerning normal UPS operation as

Interface Display

well as faults.

Emergency Power Off

This red Emergency Power Off (EPO) pushbutton is used to stop the unit during

 

an emergency situation only. All power is removed from the load.

Load not protected LED

This red LED turns on when any of these conditions occur:

 

Direct supply of power to the load by AC input power via the "Static Switch"

 

because of Inverter shutdown (voluntary or following an overload or an

 

internal fault).

 

Battery power is not available. Battery circuit breaker is in the "OFF" position

 

or battery not connected.

Fault LED

This yellow LED indicates an operating fault or an environmental fault. However,

 

the load continues to be supplied by the Inverter.

Battery Status LED

This yellow LED indicates:

 

Inverter operation on battery power following an AC input failure or detection

 

of an AC input voltage outside of tolerances.

 

It flashes to indicate that the low battery shutdown warning level has been

 

reached.

 

If the LED flashes when the system is not on battery power, battery

 

conditions should be checked.

Load protected LED

This green LED indicates that the Comet is operating normally. The load is

 

protected and supplied via the Inverter output. Bypass Switch SR1 must be in the

 

"NORMAL" position.

Inverter on

This green pushbutton is used to start the inverter.

Inverter off

This gray pushbutton is used to stop the inverter.

Fault Reset

This key clears the faults stored in memory. Clearing of alarms in memory is

 

accepted only after the alarm conditions themselves have been corrected.

Security Key

This key enables forced operation. The security key must be held down while the

 

desired function is executed. Refer to the Forced Transfer section.

Buzzer Reset

This key allows the user to silence the buzzer after a particular alarm. However,

 

the buzzer will sound if another alarm occurs.

3 —4

Operation

86-160310-00 E00

Image 36
Contents Comet 40-150kVA Page Comet Revision HistoryImportant Safety Instructions Comet 40-150kVACertification Standards Three Phase UPS Safety of PersonsProduct Safety Special PrecautionsThis page left blank intentionally Contents Maintenance OperationMGE Warranty & Proprietary Rights for Three Phase Products Warranty and Product RegistrationCustomer Care Center Three Phase Products TablesUPS Serial Number Battery Serial Number This page left blank intentionally 86-160310-00 E00 Comet 40-150kVA Symbol Usage Section DescriptionsSystem Description and Specifications ScopeGeneral Description Single Line Diagram for the Comet 40-80kVA Major Components Detail Behind Item Rear View of the Comet 40-80kVA FU1-FU21 Control Fuses TOP Conduit Landing for Cable Access to Pcas Specifications Phases WiresPower factor DC Ratings Battery voltage 25 CEnvironmental Specifications Temperature 6 DB15 Connector Pinouts and DesignationsHumidity AltitudeOptions and Accessories Chaptername This page left blank intentionally Installation ReceivingHandling For assistancePrerequisite to Installation StorageMay adversely affect life EnvironmentalShort circuit when the unit is working on Static Switch Proper trip settingsMechanical ElectricalInstallation Procedures ConnectionsBattery AC OutputChaptername This page left blank intentionally Power Flow Power Flow, For Normal OperationPower Flow, For On Battery Operation OperationGraphical User Interface, Controls and Indicators Power Flow, For Bypass OperationComet Front Panel GUI, Controls and Indicators Emergency Power Off Fault LEDBattery Status LED Fault ResetStartup Procedures Inverter Manual StartupPreliminary Checks Operating Procedures Operation on Battery PowerBattery Duration Return to AC PowerOutput Current Overload Curve Emergency Shutdown Using EPO/REPO Maintenance BypassForced Transfer Move the fan control switch SR2 to the OFF position Shutdown Procedures AlarmsPowering Down Inverter ShutdownMaintenance Battery SafetyPreventive Maintenance Replacement Parts Level DescriptionApplicable within the United States, Canada and Mexico Warranty Extension Warranty+ User InformationProduct Information MGE Customer Care Center Three Phase Products Technical Support and Product ServicesScheduling Field Service Engineer Support Return Policy for Repair of Three Phase Products RGAComet 40-150kVA Glossary Term used Definition / MeaningFCC NEC This page left blank intentionally Reorder Form Scenic Avenue Costa Mesa, CA Page Page Contact MGE