AGFA Printer manual Ink Circuit, Main ink tanks, Auto ink supply, Sub Ink Tank

Page 10

:ANAPURNA L/XL

OPERATOR MANUAL

5. Ink Circuit.

5.1.Main ink tanks

-The main ink tanks are located on the right side of the engine.

-1.6 liter per color

-Low level detection at 0.3l. (± 4h to print) Audible & visual alarm on the Signal tower.

-Ink can be refilled in while printing

-White ink tank has a continuous working stirring rod inside.

-Tanks:

WARNING

ONLY refill with the 1liter bottle, when the low level alarm goes off.

At that point, you can pour in a complete 1L bottle, and you won’t have any

left over ink remaining in the bottle!!

5.2.Auto ink supply

-From the ink tank, ink is pumped into the “Sub ink tank”, which is positioned on the Head Carriage.

-The Sub ink tank is temperature controlled, and has a content of 35ml per color

5.3.Sub Ink Tank

-Temperature setting “Sub Ink Tank”

Color:	38°C
White Ink:	40°C when in use (up to max 45°C)
	35°C when not in use

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]10]8/09/2006]

Image 10

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceColor gamut Anapurna UV Curable InkGeneral information PackingAuto ink supply Ink CircuitMain ink tanks Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankLamp Type Cure Default, Set or Both Curing setup and sequencesSettings in software UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Display Printing Progress Anapurna Control ProgramControl Program Menu Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPreparing the Anapurna Printing an imagePreparing an image Carriage must be moved to the home position firstPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Media corners lift a bit up rigid media Tips & TricksPrinting on heat sensitive media Image size/border Wasatch Rip