AGFA Printer manual To end this test, select Reset Test in the same menu

Page 38

:ANAPURNA L/XL

OPERATOR MANUAL

11.3.4. H-Orientation Test:

This test is used to align all the heads, in reference to the Black head, both horizontal and perpendicular.

When the engine is installed, or a print head has been exchanged, this test is carried out by a technician.

11.3.5. Parameter Download:

After you’ve changed a parameter in the Setup file, which was marked with an “”, use this feature to validate those new values.

11.3.6. Carriage Release Test:

This feature is mainly intended for a Service engineer, it allows the release of the Carriage motor, which is normally anchored on both side’s.

After executing, it’s possible to move the Carriage by hand from right to left.

	Do NOT to push or pull on the UV-lamps.
	ONLY push on the back of the carriage!

IMPORTANT:	To end this test, select “Reset Test” in the same menu, the
	Carriage will move slowly back to the Home position.

11.3.7. Reset Test:

This will Reset the printer.

11.3.8. Enc. Count Test:

This test will measure the Encoder pulse.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]38]8/09/2006]

Image 38

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceColor gamut Anapurna UV Curable InkGeneral information PackingAuto ink supply Ink CircuitMain ink tanks Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankLamp Type Cure Default, Set or Both Curing setup and sequencesSettings in software UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Auto Feed System Media SetupRoll to Roll Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Display Printing Progress Anapurna Control ProgramControl Program Menu Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPreparing the Anapurna Printing an imagePreparing an image Carriage must be moved to the home position firstPrinting the image Purge function on the printing Cancel a printWhile printing, press S and Y, the print is then cancelled Media corners lift a bit up rigid media Tips & TricksPrinting on heat sensitive media Image size/border Wasatch Rip