AGFA Printer manual Ink Refill System what can go wrong…, Waste Tank

Page 15

:ANAPURNA L/XL

OPERATOR MANUAL

5.6.Ink Refill System – what can go wrong…

-Wrong ink in Main ink tank:

-Observed during ink-fill:

-Press emergency stop.

-Drain main tank, taps are situated behind a plate, under the Ink Tank Indicator.

-Rinse the main tank with cleaning solution, by using a squeeze bottle.

-Fill the ink tank again, and bleed the ink-filter

-The Ink filters are situated behind the Refill System panel

Loosen top cap (2) of filter Push “Manual feeding” button till ink drips out of top cap Close top cap, tighten by hand

-Observed during printing:

-The customer needs to call the Service Engineer

-“Empty” and “Feeding” led stay lighted ON:

-Operator:

-Check the ink level in the tank visually

-Push the Manual Feed button

If the problem persists….

-Push emergency stop and restart the system If the problem persists….

-Call the Service Engineer

5.7.Waste Tank

-When the waste tank is full, the blue lamp

will flash on the Signal tower, together with

a beep-alarm.

-The waste tank is located under the conveyor belt, on the Purge-side of the engine.

Open the tap underneath to empty the tank.

-Make sure the UV-ink is kept separately from solvent ink, do not mix them in a waste container.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]15]8/09/2006]

Image 15

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyPacking Anapurna UV Curable InkGeneral information Color gamutSub Ink Tank Ink CircuitMain ink tanks Auto ink supplyRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…UV Curing System Curing setup and sequencesSettings in software Lamp Type Cure Default, Set or BothUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Set Top forward and Left Margin Anapurna Control ProgramControl Program Menu Display Printing ProgressSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Carriage must be moved to the home position first Printing an imagePreparing an image Preparing the AnapurnaPrinting the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Image size/border Wasatch Rip Tips & TricksPrinting on heat sensitive media Media corners lift a bit up rigid media