AGFA Printer manual Anapurna Control Program, Control Program Menu, Display Printing Progress

Page 32

:ANAPURNA L/XL

OPERATOR MANUAL

11. :Anapurna Control Program.

11.1. Control Program Menu

The :Anapurna Control program on the engine’s PC:

1	: IMAGE display window
2	: IMAGE SIZE display window	9	: Setup Menu, to Change Parameters
3	: Move Carriage to “Purge” position	10	: Press to Open TEST menu
4	: Move Carriage to ‘Home” position	11	: Select PASS mode
5	: Move loaded media Fwd/Back	12	: Push to start Printing
6	: STATUS Message display window	13 : Open image file(.rtl) to be printed (*)
7	: Display Printing Progress	14	: Lift head to highest position (>50mm)
8	: Set Top (forward) and Left Margin	15	: Select to Uni-Directional printing (**)

(*)When you open an image file (.rtl), which is sent from the Rip station, you’ll get an on-screen preview and it will also show the image size and nr. of passes the image is ripped for. (if an image is ripped for 6 pass, and you print it at 8 pass, it will result in an un-proportionally scaled printout)

(**)Regardless the image file, you can always choose between printing Uni- or Bi-directional.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]32]8/09/2006]

Image 32

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceAnapurna UV Curable Ink General informationColor gamut PackingInk Circuit Main ink tanksAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankCuring setup and sequences Settings in softwareLamp Type Cure Default, Set or Both UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Auto Feed System Media SetupRoll to Roll Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Anapurna Control Program Control Program MenuDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPrinting an image Preparing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image Purge function on the printing Cancel a printWhile printing, press S and Y, the print is then cancelled Tips & Tricks Printing on heat sensitive mediaMedia corners lift a bit up rigid media Image size/border Wasatch Rip