AGFA Printer manual Good

Page 34

:ANAPURNA L/XL

OPERATOR MANUAL

How to check the Bi-Dir Alignment:

Use a small image( 15cmx15cm), with text and a smooth background.

Evaluate the text sharpness and image smoothness.

As an indication, you can stop the print when it’s over half way.

By doing this, you’ll have a print with unfinished passes at the end, helping you to evaluate the alignment.

The Bi-Dir can be out of focus, left or right:

Look at the end of the interrupted print:

(A) Too much left

(B) GOOD

(C) Too much right

Change the Bi-Dir Value

Change the Bi-Dir Value

from e.g.: -4965 to -4980

from e.g.: -4965 to -4950

After changing, use “Save as”, and make a new .dat-file. (e.g.: s-1250_2mm_flex.dat) In the TEST menu, select “Parameter Download”, the new value will be active.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]34]8/09/2006]

Page 33 Page 35
Image 34
Page 33 Page 35
Contents
Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceColor gamut Anapurna UV Curable InkGeneral information PackingAuto ink supply Ink CircuitMain ink tanks Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankLamp Type Cure Default, Set or Both Curing setup and sequencesSettings in software UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Display Printing Progress Anapurna Control ProgramControl Program Menu Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPreparing the Anapurna Printing an imagePreparing an image Carriage must be moved to the home position firstPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Media corners lift a bit up rigid media Tips & TricksPrinting on heat sensitive media Image size/border Wasatch Rip