AGFA Printer manual Engine is NOW Ready to Print Again

Page 25

:ANAPURNA L/XL

OPERATOR MANUAL

STARTUP -- preparing the engine to print again:

-Remove the capping plate.

-Turn the compressed air back on. (still at “0” on display)

-Switch ON the main power switch in the engine’s fuse box.

-Pull the emergency stop back outwards.

-Startup the engine and switch the engine’s PC back on. (ATTN.: carriage will move slowly to the Home position)

-Move the carriage back to the Purge position.

-Switch all ink valves back to “I”

-Perform a long purge, until you see ink appearing out of the heads.

-Let the ink drip for 1 minute

-Set the vacuum pressure back to “-.034”. (Negative Pressure)

-Clean the heads and base plate.

-Perform a nozzle check and purge again if necessary.

-THE ENGINE IS NOW READY TO PRINT AGAIN -

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]25]8/09/2006]

Image 25

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyGeneral information Anapurna UV Curable InkColor gamut PackingMain ink tanks Ink CircuitAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…Settings in software Curing setup and sequencesLamp Type Cure Default, Set or Both UV Curing SystemUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Control Program Menu Anapurna Control ProgramDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Preparing an image Printing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Printing on heat sensitive media Tips & TricksMedia corners lift a bit up rigid media Image size/border Wasatch Rip