AGFA Printer manual AB368/09/2006

Page 36

:ANAPURNA L/XL

OPERATOR MANUAL

11.2.4. Feed Speed:

This is the forward speed of the conveyor belt between the print passes. A Feed Speed of “500” is considered the default.

No changes have to be made, unless you print at a high speed/low pass, and the conveyor belt is STILL feeding forward when the carriage already started to print the next pass.

11.2.5. UV Options:

See chapter “6.2. Curing setup and sequences”, for detailed info.

11.2.6. Head Gap Control:

See chapter “10.1. Automatic “Head Base Height” Setup”, for detailed info.

11.2.7. Factory Set:

This button is password protected.

It can only be used by an Agfa trained technician.

11.2.8. Head Offset:

These are the Head alignment settings for each head, in reference to the Black head. This alignment is done in advance by an engineer, do NOT change these values!

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]36]8/09/2006]

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceAnapurna UV Curable Ink General informationColor gamut PackingInk Circuit Main ink tanksAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankCuring setup and sequences Settings in softwareLamp Type Cure Default, Set or Both UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Anapurna Control Program Control Program MenuDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPrinting an image Preparing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Tips & Tricks Printing on heat sensitive mediaMedia corners lift a bit up rigid media Image size/border Wasatch Rip
Top Page Image Contents