AGFA Printer manual Cancel a print, Purge function on the printing

Page 41

:ANAPURNA L/XL

OPERATOR MANUAL

12.4. Cancel a print

While printing, press “S” and “Y”, the print is then cancelled.

12.5. Purge function on the printing

While printing, press “S” and “N”, at ‘Purge Request?’ select “Y”, the carriage will move to the Purge position. After the Purge intervention, press the “OK” button to continue printing.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]41]8/09/2006]

Image 41

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyGeneral information Anapurna UV Curable InkColor gamut PackingMain ink tanks Ink CircuitAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…Settings in software Curing setup and sequencesLamp Type Cure Default, Set or Both UV Curing SystemUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Auto Feed System Media SetupRoll to Roll Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Control Program Menu Anapurna Control ProgramDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Preparing an image Printing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image Purge function on the printing Cancel a printWhile printing, press S and Y, the print is then cancelled Printing on heat sensitive media Tips & TricksMedia corners lift a bit up rigid media Image size/border Wasatch Rip