:ANAPURNA L/XL | OPERATOR MANUAL |
6.3.Uni- and Bi-directional printing
-For Bi-directional printing, both UV lamps need to be used. (curing is done on the fly in both printing directions)
-For Uni-directional printing, only the right UV lamp will be used. (curing is only done when the shuttle is moving from right to left)
Depending on the heat-resistance/thickness of your media, you can set the UV lamp power to “Half” or “Full” power.
By default, “Full” power should be used whenever possible.
When switching ON the UV-lamps, don’t switch them from “Off” to “Full” power at once. Wait 2 seconds at “Half” power before switching them to “Full“ power. Use the same procedure when going from Full power to Off.
AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]17]8/09/2006]
