AGFA Printer manual Maintenance, Replacement of Conveyor belt

Page 19

:ANAPURNA L/XL

OPERATOR MANUAL

7.3.Maintenance

-Always make sure, when printing “borderless”, that the belt is masked, so printing on the belt is reduced to a minimum.

-When you have printed onto the Conveyor belt, try to remove the ink with a cleaning solution.

7.4.Replacement of Conveyor belt

-Vacuum can become insufficient when the belt is completely printed. The Conveyor belt therefore is a Spare Part, and can be ordered as such.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]19]8/09/2006]

Image 19

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyPacking Anapurna UV Curable InkGeneral information Color gamutSub Ink Tank Ink CircuitMain ink tanks Auto ink supplyRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…UV Curing System Curing setup and sequencesSettings in software Lamp Type Cure Default, Set or BothUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Set Top forward and Left Margin Anapurna Control ProgramControl Program Menu Display Printing ProgressSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Carriage must be moved to the home position first Printing an imagePreparing an image Preparing the AnapurnaPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Image size/border Wasatch Rip Tips & TricksPrinting on heat sensitive media Media corners lift a bit up rigid media