AGFA Printer manual Take-Up Motor Box

Page 27

:ANAPURNA L/XL

OPERATOR MANUAL

9.1.2.Take-up control system

(1)In Manual Mode, motor rotates CW

(2)In Manual Mode, motor rotates CCW

(1)+(2) You can RESET by pushing buttons for 1 sec

(3)- In Auto Mode: select motor direction (CW or CCW)

- In Manual Mode: select motor (Back or Front)

(4)Select Mode (Manual or Auto)

Take-Up Motor Box

9.1.3. Roll Alignment

When the roll media is loaded, measure the distance from the right side (A) to the point where you want to start printing.

Enter this value on the engine’s Control Program, as a Left Margin.

9.1.4. Vacuum

For roll media, even at full engine width, you should only use vacuum table 1. (for more info: see chapter 7.1)

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]27]8/09/2006]

Image 27

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyPacking Anapurna UV Curable InkGeneral information Color gamutSub Ink Tank Ink CircuitMain ink tanks Auto ink supplyRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…UV Curing System Curing setup and sequencesSettings in software Lamp Type Cure Default, Set or BothUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Set Top forward and Left Margin Anapurna Control ProgramControl Program Menu Display Printing ProgressSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Carriage must be moved to the home position first Printing an imagePreparing an image Preparing the AnapurnaPrinting the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Image size/border Wasatch Rip Tips & TricksPrinting on heat sensitive media Media corners lift a bit up rigid media