AGFA Printer manual Way valves

Page 12

:ANAPURNA L/XL

OPERATOR MANUAL

5.4. The 2-Way valves

-Normal printing:

-The color valves are positioned in the “I” direction. The ink can flow to the head.

-Purging the heads:

-In case of clogged nozzles, or misfiring nozzles; Push the “Purge” button at very short intervals, this will cause ink flowing through the heads, this will un-clog the missing nozzles.

(make sure the Grid is pushed to the back)

-Cleaning the heads with Cleaning solution:

-The color valves must be “closed”, set them to

the “S” direction. Now, the ink flow to the heads is closed. Open the Cleaning Solution “control valve” on the right. When you now push the “Solution-Purge” button on

the BACK of the shuttle, Cleaning solution will flow through your heads to un-clog the missing nozzles.

THE APPROPRIATE WAY OF WORKING, FOR PERFORMING A NOZZLE CHECK,

AND JUDGING MISFIRING NOZZLES,

CAN BE FOUND IN THE MAINTENANCE CHAPTER.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]12]8/09/2006]

Image 12

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceAnapurna UV Curable Ink General informationColor gamut PackingInk Circuit Main ink tanksAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankCuring setup and sequences Settings in softwareLamp Type Cure Default, Set or Both UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Anapurna Control Program Control Program MenuDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPrinting an image Preparing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Tips & Tricks Printing on heat sensitive mediaMedia corners lift a bit up rigid media Image size/border Wasatch Rip