AGFA Printer manual UV Curing System, Curing setup and sequences, Settings in software

Page 16

:ANAPURNA L/XL

OPERATOR MANUAL

6. UV Curing System.

6.1.General information

-2 UV sources positioned in front of and behind head base plate

-High speed on-the-fly curing

-Curing power: 120 W/cm

-2 fixed settings: Full and half strength

-Air cooled lamp-house

-Quick and easy replacement of the UV-bulbs

(Always change both the lamps !!)

-Expected lifetime ± 1000 hours

-Use of an automated shutter system

6.2.Curing setup and sequences

-Settings in software:

-Lamps continous ON (lamp stays “ON” for next print; longest lifetime)

-WarmUp Time (when turning back on the UV lamps, before ready state)

-Cooling Time (after turning off the UV lamps)

-Lamp Type: Cure (Default), Set or Both

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]16]8/09/2006]

Image 16

Contents Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System DimensionsFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color SequenceAnapurna UV Curable Ink General informationColor gamut PackingInk Circuit Main ink tanksAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressureEncoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste TankCuring setup and sequences Settings in softwareLamp Type Cure Default, Set or Both UV Curing SystemBy default, Full power should be used whenever possible Uni- and Bi-directional printingPrinting Table Belt Tension controlMaintenance Replacement of Conveyor beltMaintenance Daily Maintenance Nozzle check/purgeLittle purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the WeekLong Stand Still Engine is NOW Ready for a Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tablesAB298/09/2006 Automatic Head Base Height Setup Head Base Height ControlMm Gap Anapurna Control Program Control Program MenuDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home positionPrinting an image Preparing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Tips & Tricks Printing on heat sensitive mediaMedia corners lift a bit up rigid media Image size/border Wasatch Rip