AGFA Printer manual Test Menu

Page 37

:ANAPURNA L/XL

OPERATOR MANUAL

11.3. Test Menu

11.3.1. Jet Test:

See chapter “8.2. Daily Maintenance – Nozzle check/purge”

11.3.2.Feed Step Test:

11.3.3.Nozzle Test:

This allows you to test 1 nozzle of a particular head.

The requested nozzle is printed in a straight line.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]37]8/09/2006]

Image 37

Contents Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and FeaturesFront view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technologyGeneral information Anapurna UV Curable InkColor gamut PackingMain ink tanks Ink CircuitAuto ink supply Sub Ink TankRead out How to make changes 2-Way valves Ink supply by means of negative pressure Printing headsEncoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong…Settings in software Curing setup and sequencesLamp Type Cure Default, Set or Both UV Curing SystemUni- and Bi-directional printing By default, Full power should be used whenever possibleBelt Tension control Printing TableReplacement of Conveyor belt MaintenanceDaily Maintenance Nozzle check/purge MaintenanceLittle purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly MaintenanceEngine is NOW Ready for a Long Stand Still Long Stand StillEngine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Support tables Rigid MediaAB298/09/2006 Head Base Height Control Automatic Head Base Height SetupMm Gap Control Program Menu Anapurna Control ProgramDisplay Printing Progress Set Top forward and Left MarginSetup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu,Preparing an image Printing an imagePreparing the Anapurna Carriage must be moved to the home position firstPrinting the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Printing on heat sensitive media Tips & TricksMedia corners lift a bit up rigid media Image size/border Wasatch Rip